Aruba Central allows administrators to schedule software and firmware upgrades, giving control over when updates are applied to network devices for minimal disruption.

To add a new member to an existing CX 6200F VSF stack, the new switch must be pre- provisioned as a standby member. This ensures it can correctly join the existing VSF topology and integrate into the stack without disrupting current operations.

Explanation:
The CX 6200 and CX 6300 series support large VSF stacks, enabling multi-member single- control-plane resiliency. The CX 6100 supports VSF with a smaller maximum stack size. The CX
8100 does not support VSF but instead uses VSX, where two independent switches provide redundancy. The CX 4100i does not support VSF or VSX, so no OS-based device redundancy is available.

To configure a CX 6300 switch port as a routed L3 interface without bridging, you enable routing on the interface and assign an IP address, while also configuring it as an access VLAN if needed and ensuring the interface is not shut down.

SNMPv3 is considered secure because it supports authentication and encryption, protecting management traffic from unauthorized access and eavesdropping.