Online Access Free HP.HPE7-A08.v2026-02-28.q62 Practice Test (Page 2)

HPE7-A08 Exam Question 1

You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSID. End-users are complaining that they can't connect to the enterprise SSID. Which possible AP tunnel states could be the cause of the issue? (Select two.)

A.SM_STATE_CONNECTED

B.SM_STATE_SURVIVING

C.SM_STATE_CONNECTING

D.SM_STATE_SURVIVED

E.SM_STATE_REKEYING

HPE7-A08 Exam Question 2

What should you configure for an interface connected to a device you cannot trust to assign DSCP markings? (Select two.)

A.Apply a dscp-map to the interface to assign a Local Priority value

B.Configure "qos trust none"

C.Configure Weighted Fair Queuing

D.Apply a classifier-based policy to the interface to assign a Local Priority value

E.Configure "qos trust cos"

HPE7-A08 Exam Question 3

A customer is running out of IP addresses in a network segment. What will happen if they add an additional IP subnet to the same VLAN?

A.Users can reach each other and establish PTP traffic without passing an L3 point in the same VLAN

B.This would result in a single SVI using two subinterfaces

C.Broadcasts for the two subnets will arrive on all ports in the same VLAN

D.IGMP will not work in both of the subnets in the same VLAN

HPE7-A08 Exam Question 4

In a WLAN network with a tunneled SSID, you see the following events in HPE Aruba Networking Central:

The customer asks you to investigate log messages. What should you tell them?

A.This is normal, expected behavior. No further actions are needed

B.This indicates a security issue. The client with a MAC address ending with 37:18:0d is performing a Denial-of-Service attack on your network. You should track down the client and remove it from the network

C.This indicates a client WLAN driver issue for the client with a MAC address ending with 37:18:0d.
You should upgrade the client WLAN driver

D.There is a roaming issue. Enable Fast Roaming 802.11r and OKC to resolve the issue

HPE7-A08 Exam Question 5

The output of the show LACP interfaces shows the following:

What is causing this issue?

A.Each AP interface is connected to a routed-only interface on different networks.

B.e0 is connected to a smart rate interface, and e is connected to a non-smart rate interface.

C.Spanning tree and loop protect are enabled on both AP uplink ports.

D.The AP is configured with LACP active.

Other Version: 1061HP.HPE7-A08.v2026-06-29.q105; 1376HP.HPE7-A08.v2026-05-07.q63; 592HP.HPE7-A08.v2026-04-16.q39; 1357HP.HPE7-A08.v2025-12-30.q137; 1076HP.HPE7-A08.v2025-12-13.q70; 1023HP.HPE7-A08.v2025-11-12.q99

Latest Upload: 127SAVEInternational.CVS.v2026-09-04.q65; 115Fortinet.NSE6_FSM_AN-7.4.v2026-09-04.q20; 119USGBC.LEED-Green-Associate.v2026-09-04.q201; 145Microsoft.AB-731.v2026-09-03.q37; 128TheSecOpsGroup.CCPenX-Az.v2026-09-03.q15; 213EMC.D-VXR-DY-01.v2026-09-03.q159; 338EC-COUNCIL.312-49.v2026-09-02.q265; 142PECB.ISO-IEC-27002-Foundation.v2026-08-31.q16; 232Microsoft.SC-900.v2026-08-31.q125; 192GIAC.GRID.v2026-08-31.q57

HPE7-A08 Exam Question 1

HPE7-A08 Exam Question 2

HPE7-A08 Exam Question 3

HPE7-A08 Exam Question 4

HPE7-A08 Exam Question 5

Download PDF File