Refer to the exhibit:

How can you implement route summarization for the routes originating from Area 2?

Refer to the exhibit:

A senior network architect has created the configuration above. You are implementing the setup in building A and D.
The actual fiber distance between the building locations is: 90m / 295ft utilizing 0M4 cabling.
What needs to be changed on the configuration based on the actual environmental conditions or is valid about the configuration?

You are configuring OSPF on each of the devices shown. After verifying the OSPF neighbor table on each, you notice that Router-1 and Access-1 have neighbors in the 2WAY state. What is the reason for this?

Drag and Drop Question
Company A has an existing HPE Aruba Networking CX 8325 VSX. It has acquired Company B and must merge its networks onto the same VSX switch configuration as Company A. Both Company A and Company B share the same 10.100.100.1/24 subnet.
What is the correct order for creating a configuration allowing overlapping networks in the setup?

Using the configuration below, you have configured OSPF at a small branch site, which only requires a single default route to reach the Internet and all other sites. When examining the routing table, you still see other OSPF routes besides the default route.

What OSPF area type should you configure?