Explanation
A: In EAP termination mode, an access device encapsulates EAP packets sent by an 802. IX client Into RADIUS packets, without processing the data in the EAP packets. This statement is false because in EAP termination mode, an access device extracts information from EAP packets, encapsulates the information into RADIUS packets, and sends the RADIUS packets to an authentication server2.
D: The EAP termination mode simplifies the processing on an access device and supports various authentication methods. However, this mode requires an authentication server to support EAP and have high processing capability. This statement is false because it describes the EAP relay mode, not the EAP termination mode2.
Therefore, A and D are the correct answers. References: 2:
https://support.huawei.com/enterprise/en/doc/EDOC1100086527

Customer Requirement Specification
Customer Requirement Specification (CRS) is a document that needs to be output after the project requirements are clarified. The CRS describes the customer's requirements in detail and serves as the basis for subsequent project design and delivery.
References: https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/crs

Explanation
The display sync-configuration compare command is used to check whether the public configurations on two WACs are consistent after wireless configuration synchronization. The command output shows the differences between the configurations on the master and backup WACs. In this case, the configuration of vap-profile name 3 exists on the master WAC but not on the backup WAC.
References:
https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/display-sync-configuration-compare

Explanation
According to the Huawei documents and resources, the chronological order during the 802.11r fast roaming process between WACs is as follows:
2.The STA accesses the network through API. This is the initial association process before roaming.
1.The STA initiates an 802.11 FT authentication request to AP2. This is the first step of the roaming process when the STA moves to a new AP.
3.AP2 starts the reassociation timer, and sends an 802.11 FT authentication response to the STA. This is the second step of the roaming process when AP2 responds to the STA's request and sets a timer for reassociation.
4.The STA generates and installs a P TK based on the information contained in the response frame. This is the third step of the roaming process when the STA derives a new pairwise key for encryption.
5.The STA sends a reassociation request to AP2. This is the fourth step of the roaming process when the STA requests to reassociate with AP2.
6.AP2 generates and installs a PTK according to PMK-RI and information contained in the request frame. This is the fifth step of the roaming process when AP2 derives the same pairwise key as the STA.
7.After receiving the reassociation request, AP2 disables the reassociation timer, and then sends a reassociation reg onse to the STA. This is the sixth step of the roaming process when AP2 confirms the reassociation with the STA and stops the timer.
8.The STA receives the response frame of AP2. The roaming process is complete. This is the final step of the roaming process when the STA completes the handover to AP2.
Therefore, 2, 1, 3, 4, 5, 6, 7, 8 is the correct answer. References:
https://support.huawei.com/enterprise/en/doc/EDOC1100169459/8d79210e/configuring-wireless-mesh-networki

Explanation
A is false because in the mini-store scenario, APs can directly connect to egress links and support NAT if Wi-Fi coverage is required. There is no need to deploy egress devices separately.
References: https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/access-layer-design