The output information of the sub-interface of a router aggregate port 1 is shown in the figure. Based on this information, which of the following statements are correct? (Multiple Choice)
[Router A]display Interface Eth-Trunk 1.100
Eth-Trunk1.100 current state : UP
Line protocol current state : UP
Last line protocol up time : 2019-03-04 10:22:40 UTC -08 :00
Description: HUAWEI, AR Series, Eth-Trunk1.100 Interface
Route Port, Hash arithmetic : According to SIP-XOR-DIP, Maximal BW: 2G, Current BW: 2G, The Maximum Transmit Unit is 1500
Internet Address is 10.0.12.2/24
IP Sending Frames' Format is PKTFIT ETENT 2.Hardware address 1s 00e0-fc3b-2015
Current system time: 2019-03-04 10:24:29 -08:00
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds input rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds output rate 0 bits/sec, 0 packets/sec
Input: 6 packets, 574 bytes,
Output:7 packets, 638 bytes,
Input bandwidth utilization ;0%
Output bandwidth utilization :0%
--------------------------------
PortName Status Weight
--------------------------------
GigabitEthernet0/0/1 UP 1
GigabitEthernet0/0/2 UP 1
--------------------------------
The Number of Ports in Trunk : 2
The Number of UP Ports in Trunk : 2

In the campus network, network reliability can be improved by using link aggregation and stacking technology.

Switches running SIP protocol, the port needs to wait for the forwarding delay in the Learning state before it can be transformed into the Forwarding state.

Which of the following features does the default VLAN in the Layer 2 Ethernet switch have? ()*

The NAT configuration is as follows, which IP can be converted when accessing the public network (RTA) acl2000 (RTA-acl-basic-2000) rule5 permit source 192.168.1.00.0.0.255 RTA-acl- basic-2000) rule 10 deny source 192.168. 1.30 (RTA-acl-basic-2000) quit RTA) interface serial1/0/0 (RTA-Serial1/0/0) nat outbounD.2000*