In MPLS LDP, there are two types of sessions:
Direct LDP sessions: Established between directly connected LSRs using LDP Hellos over a link.
Remote LDP sessions (also called targeted LDP sessions): Established between non-directly connected LSRs.
These requiremanual configurationof the remote peer.
In this scenario, SWA and SWC arenot directly connected, so aremote (targeted) LDP sessionmust be set up.
For a remote LDP session:
Youmust configure the remote peerusing the command:
[SWA-MPLS-LDP] targeted-peer x.x.x.x
Where x.x.x.x is theLSR ID of SWC(33.3.3.3 in this case).
The current configuration does not include this required step.
Thus, the correct statement is:
D). You need to create a remote peer and specify an LSR ID for the remote peer.
Reference:Huawei HCIE-Datacom V1.0 Study Guide -Chapter: MPLS LDPSection: Establishing LDP Sessions (Direct and Targeted)

Comprehensive and Detailed Explanation:
#SRv6 (Segment Routing over IPv6)works byencoding a segment list in the IPv6 header.
#How SRv6 Works:
TheSegments Leftfield indicates theremaining segmentsin the path.
Eachendpoint node processes the next segmentand decrementsSegments Leftby 1.
TheIPv6 Destination Address (DA) is updatedto the next segment.
Thus, the statement isTRUE.
#Reference:Huawei HCIE Datacom - SRv6 Packet Forwarding

80HTTP
(Hypertext Transfer Protocol)is the foundation of web communication and is widely used in Huawei'sOPS (Open Programmability System)to manage devices via RESTful APIs.According to standardIANA port assignments, HTTP uses:TCP port 80 by defaultHTTPS (secured HTTP) usesTCP port
443Huawei OPS interacts with network devices usingHTTP (or HTTPS)protocols for script-driven automation, and unless secured HTTPS is specified,port 80is the standard.Correct answer: 80 Reference:
IANA Service Name and Port Number Registry: https://www.iana.org/assignments/service-names-port- numbers Huawei HCIE-Datacom V1.0 Study GuideChapter:Network Automation and ProgrammabilitySection:OPS Fundamentals and HTTP Communication

Comprehensive and Detailed In-Depth Explanation:
TheHuawei SD-WAN SolutionusesHTTP/2as the primary protocol toreport device performance datato the controller.
HTTP/2is chosen for itshigh efficiency, low latency, and enhanced data transfer speed.
It supportsbidirectional communicationbetween devices and the iMaster NCE-Campus controller.
While protocols likeNetFlowandSNMPare traditionally used for monitoring, Huawei SD-WAN specifically usesHTTP/2for real-time performance reporting and control due to its modern web-based architecture.
Reference:
Huawei HCIE Datacom Official Certification Guide
Huawei SD-WAN Solution Guide
Huawei iMaster NCE-Campus Documentation

On the2.4 GHzband, onlythree non-overlapping channelsexist:1, 6, and 11.
Inhigh-density WLAN scenarios, channels like1, 5, 9, and 13can be used withlower transmit powerto reduce co-channel interference - though they slightly overlap, they can work in dense deployments when managed properly.
On the5 GHzband, there are many non-overlapping channels. It's recommended tostagger high and low channelsamong adjacent APs toavoid interference.
Correct answer: A. TRUE
Reference:Huawei HCIE-Datacom V1.0 Study Guide -Chapter: WLAN Planning and OptimizationSection:
Channel and Frequency Selection Strategies