A.Layer 2 networking + direct connection + tunnel forwarding

B.Layer 2 networking + direct connection + direct forwarding

C.Layer 3 networking + bypass + tunnel forwarding

D.Three-layer networking + bypass + direct forwarding

A.It is recommended to turn on automatic tuning in high-density stadiums or video return scenarios.

B.In outdoor scenarios or special scenarios, it is recommended to install the network planning results for power configuration.

C.Indoor scenarios are mainly cellular deployments. Automatic tuning can be used for channel power deployment to avoid coverage congestion due to the configured signal transmission power being too small or signal mutual interference caused by the configured signal power being too high.

D.The signal strength (RSSI) of the WLAN network coverage area needs to reach -65dBm to meet a good network coverage experience.

A.Portal page customization is not supported, but docking with third-party Portal servers is supported.

B.Support docking with social media such as WeChat

C.Authentication data is transmitted using HTTP2.0 and Radius protocols, and configuration data is transmitted using Netconf protocol.

D.The authentication method supports Portal authentication, MAC authentication, and 802.1X authentication.

A.If no SRv6 TE Policy is matched, select the SRv6 TE Policy with the default priority of other address families;

B.If no SRv6 TE Policy is matched, select the SRv6 TE Policy with the smallest address family DSCP value;

C.If no SRv6 TE Policy is matched, select the SRv6 TE Policy with the smallest DSCP value in this address family;

D.IPv4/IPv6 traffic first strictly matches the SRv6 TE Policy corresponding to the DSCP value of the corresponding address family;

A.Architecture for all-flash

B.Global shared distributed file system

C.FlashLink intelligent disk control coordination algorithm

D.End-to-end NVMe architecture