SCTP tracing result is not required to diagnose a low Internet access rate for a user. User performance testing can be used to collect information such as BLER (Block Error Rate) monitoring result, downlink RSRP (Reference Signal Received Power) monitoring result, and MCS (Modulation and Coding Scheme) count monitoring result. However, SCTP (Stream Control Transmission Protocol) tracing result is not required to diagnose a low Internet access rate. Reference: https://www.aricent.com/blog/user-performance-testing-for-5g/
https://www.gsma.com/greater-china/wp-content/uploads/2021/02/5G-Use-Cases-for-Vertical-China-2021-EN.pdf
5G Use Cases for Vertical China - 2021
https://www.gsma.com/greater-china/wp-content/uploads/2021/02/5G-Use-Cases-for-Vertical-China-2021-EN.pdf
https://www.mdpi.com/2079-9292/10/24/3175
Smart Manufacturing and Tactile Internet Based on 5G in Industry ...
https://www.mdpi.com/2079-9292/10/24/3175
https://www.cepal.org/sites/default/files/publication/files/46817/S2000960_en.pdf Digital technologies for a new future
https://www.cepal.org/sites/default/files/publication/files/46817/S2000960_en.pdf

In the data reconfiguration using the MAE-Deployment, the MOs gNodeBFuncrjon, gNBCULogicNode, and gNBDULogicNode are involved. These MOs are responsible for configuring the gNodeB functional parameters, the gNodeB CU logical nodes and the gNodeB DU logical nodes.

In NSA networking, In self-setup scenarios, the USERPLANEHOST and SCTPHOST objects are unnecessary to configure for a gNodeB. The USERPLANEHOST object is used to configure the IP address of the user plane host, and the SCTPHOST object is used to configure the IP address of the SCTP host. In self-setup scenarios, the gNodeB automatically obtains the IP addresses of the user plane host and SCTP host from the S1-MME or S1-U peer. The USERPLANEPEER and SCTPPEER objects are necessary to configure for a gNodeB in SI self-setup scenarios. They are used to configure the IP address of the user plane peer and SCTP peer, respectively.

If the NRDUCELL corresponding to NRCELL is not set up, then the NRCELL must be unavailable. This is because the NRDUCELL defines the coverage area of an NRCELL. Without the NRDUCELL, the NRCELL cannot be successfully activated and therefore it will remain unavailable.
https://www.date-conference.com/programme
Programme | DATE 2023
https://www.date-conference.com/programme
https://www.scribd.com/document/553818425/Mobility-Management-5G-RAN6-1-Draft-a Mobility Management (5G RAN6.1 - Draft A) | PDF | Duplex ...
https://www.scribd.com/document/553818425/Mobility-Management-5G-RAN6-1-Draft-a

Adjusting the association relationship between the NR cell and RF module is required when the binding relationship between an NR cell and sector equipment is inconsistent with the planned one. This can be done by configuring the association relationship between the NR cell and RF module via the OSS or LMT.