Explanation/Reference:
The Biba security model addresses the integrity of data being threatened when subjects at lower security levels are able to write to objects at higher security levels and when subjects can read data at lower levels.
Source: HARRIS, Shon, All-In-One CISSP Certification Exam Guide, McGraw-Hill/Osborne, 2002, Chapter
5: Security Models and Architecture (Page 244).

Explanation/Reference:
The Bell-LAPadula model is also called a multilevel security system because users with different clearances use the system and the system processes data with different classifications. Developed by the US Military in the 1970s.
A security model maps the abstract goals of the policy to information system terms by specifying explicit data structures and techniques necessary to enforce the security policy. A security model is usually represented in mathematics and analytical ideas, which are mapped to system specifications and then developed by programmers through programming code. So we have a policy that encompasses security goals, such as "each subject must be authenticated and authorized before accessing an object." The security model takes this requirement and provides the necessary mathematical formulas, relationships, and logic structure to be followed to accomplish this goal.
A system that employs the Bell-LaPadula model is called a multilevel security system because users with different clearances use the system, and the system processes data at different classification levels. The level at which information is classified determines the handling procedures that should be used. The Bell- LaPadula model is a state machine model that enforces the confidentiality aspects of access control. A matrix and security levels are used to determine if subjects can access different objects. The subject's clearance is compared to the object's classification and then specific rules are applied to control how subject-to-object subject-to-object interactions can take place.
Reference(s) used for this question:
Harris, Shon (2012-10-25). CISSP All-in-One Exam Guide, 6th Edition (p. 369). McGraw-Hill. Kindle Edition.

Section: Network and Telecommunications
Explanation/Reference:
The 802.11 standard outlines how wireless clients and APs communicate, lays out the specifications of their interfaces, dictates how signal transmission should take place, and describes how authentication, association, and security should be implemeted.
The following answers are incorrect:
Public Key Infrastructure (PKI) Public Key Infrastructure is a supporting infrastructure to manage public keys. It is not part of the IEEE 802 Working Group standard.
Packet-switching technology A packet-switching technology is not included in the IEEE 802 Working Group standard. It is a technology where-in messages are broken up into packets, which then travel along different routes to the destination.
The OSI/ISO model The Open System Interconnect model is a sevel-layer model defined as an international standard describing network communications.
The following reference(s) were/was used to create this question:
Source: Shon Harris - "All-in-One CISSP Exam Guide" Fourth Edition; Chapter 7 - Telecommunications and Network Security: pg. 624.
802.11 refers to a family of specifications developed by the IEEE for Wireless LAN technology. 802.11 specifies an over-the-air interface between a wireless client and a base station or between two wireless clients.
The IEEE accepted the specification in 1997. There are several specifications in the 802.11 family:
802.11 # applies to wireless LANs and provides 1 or 2 Mbps transmission in the 2.4 GHz band using either frequency hopping spread spectrum (FHSS) or direct sequence spread spectrum (DSSS).
802.11a # an extension to 802.11 that applies to wireless LANs and provides up to 54 Mbps in the 5GHz band. 802.11a uses an orthogonal frequency division multiplexing encoding scheme rather than FHSS or DSSS.
802.11b (also referred to as 802.11 High Rate or Wi-Fi) # an extension to 802.11 that applies to wireless LANS and provides 11 Mbps transmission (with a fallback to 5.5, 2 and 1 Mbps) in the 2.4 GHz band. 802.11b uses only DSSS. 802.11b was a 1999 ratification to the original 802.11 standard, allowing wireless functionality comparable to Ethernet.
802.11g # applies to wireless LANs and provides 20+ Mbps in the 2.4 GHz band.
Source: 802.11 Planet's web site.

Section: Access Control
Explanation/Reference:
When access control is based on the content of an object, it is considered to be content dependent access control.
Content-dependent access control is based on the content itself.
The following answers are incorrect:
context-dependent access control. Is incorrect because this type of control is based on what the context is, facts about the data rather than what the object contains.
least privileges access control. Is incorrect because this is based on the least amount of rights needed to perform their jobs and not based on what is contained in the database.
ownership-based access control. Is incorrect because this is based on the owner of the data and and not based on what is contained in the database.
References:
OIG CBK Access Control (page 191)

In Discretionary Access Control (DAC) environments, the user who creates a file is also considered the owner and has full control over the file including the ability to set permissions for that file.
The following answers are incorrect:
manager. Is incorrect because in Discretionary Access Control (DAC) environments it is the owner/user that is authorized to grant information access to other people.
group leader. Is incorrect because in Discretionary Access Control (DAC) environments it is the owner/user that is authorized to grant information access to other people.
security manager. Is incorrect because in Discretionary Access Control (DAC) environments it is the owner/user that is authorized to grant information access to other people.
IMPORTANT NOTE: The term Data Owner is also used within Classifications as well. Under the subject of classification the Data Owner is a person from management who has been entrusted with a data set that belongs to the company. For example it could be the Chief Financial Officer (CFO) who is entrusted with all of the financial data for a company. As such the CFO would determine the classification of the financial data and who can access as well. The Data Owner would then tell the Data Custodian (a technical person) what the classification and need to know is on the specific set of data.
The term Data Owner under DAC simply means whoever created the file and as the creator of the file the owner has full access and can grant access to other subjects based on their identity.