Online Access Free Juniper.JN0-352.v2026-07-28.q67 Practice Test (Page 4)

JN0-352 Exam Question 11

Referring to the output shown in the exhibit, which two statements are true?

A.The route is a generate route

B.The route is active

C.The route is not active

D.The route is an aggregate route

JN0-352 Exam Question 12

Your network has two ISPs available. You want to ensure that all outbound traffic is routed out ISP-1. If the connection to ISP-1 fails, all outbound traffic is routed to the backup ISP, ISP-2. In this scenario, how should you configure BGP on your network?

A.Configure the gateway for ISP-1 with a higher origin code than the gateway for ISP-2.

B.Configure the gateway for ISP-1 with a higher peer ID than the gateway for ISP-2.

C.Set the local-preference attribute to a higher value for ISP-2 than ISP-1.

D.Set the local-preference attribute to a higher value for ISP-1 than ISP-2.

JN0-352 Exam Question 13

Which two statements about redundant trunk groups on EX Series switches are correct? (Choose two.)

A.Redundant trunk groups use spanning tree to provide loop-free redundant uplinks.

B.Redundant trunk groups load balance traffic across two designated uplink interfaces.

C.Layer 2 control traffic is permitted on the secondary link.

D.If the active link fails, then the secondary link automatically takes over.

JN0-352 Exam Question 14

Which statement about the default action of MAC limiting is true when the number of MAC addresses has hit the limit set?

A.The switch will shut down the offending port for five minutes.

B.The switch stops learning MAC addresses on the offending port, and any traffic to or from the offending MAC address will be dropped.

C.The switch will shut down MAC learning on the offending port for five minutes.

D.The switch stops learning MAC addresses on the offending port, but floods traffic out of all ports for the offending MAC address.

JN0-352 Exam Question 15

Referring to the exhibit, Router-1 and Router-2 are failing to form an IS-IS adjacency.

What should you do to solve the problem?

A.Change the IP subnet masks to match on the ge-0/0/2 interfaces of both routers.

B.Remove the ISO address from ge-0/0/2 on Router-1.

C.Remove the overloaded statement from Router-1.

D.Change the ISO areas on the lo0 interfaces to match on both routers.

Latest Upload: 145Cisco.300-515.v2026-07-29.q81; 122Cisco.350-101.v2026-07-29.q43; 162Microsoft.PL-900.v2026-07-29.q187; 139Fortinet.FCSS_NST_SE-7.6.v2026-07-29.q64; 116NetworkAppliance.NS0-194.v2026-07-29.q28; 172Microsoft.SC-300.v2026-07-29.q174; 139VMware.250-614.v2026-07-29.q63; 148Microsoft.AI-901.v2026-07-28.q38; 126Oracle.1Z0-1032-26.v2026-07-28.q31; 129Cisco.300-725.v2026-07-28.q64

JN0-352 Exam Question 11

JN0-352 Exam Question 12

JN0-352 Exam Question 13

JN0-352 Exam Question 14

JN0-352 Exam Question 15

Download PDF File