The correct command to change the number of days before the ext3 filesystem on /dev/sda1 has to run through a full filesystem check while booting is tune2fs -i 200 /dev/sda1. This command sets the interval between two filesystem checks to 200 days. The tune2fs command allows you to view and change various filesystem parameters on Linux ext2, ext3, or ext4 filesystems. The -i option specifies the time interval between checks. The other options are incorrect because they use the wrong parameters for the tune2fs command. Option A is wrong because the -d option is not supported by the tune2fs command. Option B is wrong because the -c option sets the maximum number of mounts, not days, before a check. Option D is wrong because the -n option is not supported by the tune2fs command. Option E is wrong because the --days option is not supported by the tune2fs command. References:
* [LPI Linux Essentials - 2.2 Mounting, Unmounting Filesystems]
* 15 tune2fs command examples in Linux [Cheat Sheet] - GoLinuxCloud
* Linux tune2fs command With Examples - GeeksforGeeks
* tune2fs command-file system management - Linuxstar
* tune2fs Command Examples - Gianforte School of Computing

The correct commands to create an ext3 filesystem on /dev/sdb1 are /sbin/mke2fs -j /dev/sdb1 and /sbin/mkfs - t ext3 /dev/sdb1. These commands format the partition /dev/sdb1 with the ext3 filesystem type. The first command uses the mke2fs utility with the -j option, which enables journaling. The second command uses the mkfs utility with the -t option, which specifies the filesystem type. Both commands are equivalent and can be used interchangeably. The other options are incorrect because they use the wrong syntax or parameters for the commands. Option C is wrong because the -c option for the mkfs command checks the device for bad blocks, not the filesystem type. Option D is wrong because there is no such utility as mke3fs. The correct utility name is mke2fs.