Which OSPFv3 LSA type is generated by an ABR to advertise prefixes from one area to another?

Which of the following commands may only be used on the head end router to verify the status of an LSP named "LSP 1"? (Choose two)

Which of the following messages is NOT used in T-LDP operation?

Click on the exhibit button below.

Assume the following:
- Each router's OSPF interfaces are in the areas shown.
- Bidirectional LDP-over-RSVP tunnels extend from routers R1 to R3 and back over the path R1-R4-R5-R3.
- You enable fast reroute facility bypass on the R5-R3 RSVP LSP.
- Router R5 acts as a PLR, protecting the R5-R3 link by building a bypass tunnel through router R2.
You build a layer 2 VPN on routers R1 and R3, using the LDP-over-RSVP tunnels.
What MPLS configuration step must you complete on router R2 for it to protect the end-to-end service?

Click on the exhibit.

All links are of equal cost. A CSPF-enabled LSP is configured on R1 to R6. Its fully loose primary path is configured with an "include green" statement and the fully loose secondary path is configured with an "include red" statement.
Which paths will be taken by this LSP?