NCP-MCI-5.15 Exam Question 21
An administrator sets up a protection domain that replicates to a remote site. The administrator must perform DR test every 6 months.
Which snapshot is used when activate is checked on the remote site`s production domain?
Which snapshot is used when activate is checked on the remote site`s production domain?
NCP-MCI-5.15 Exam Question 22
An administrator wants to configure Near Sync an AOS 5.15 implementations. The Cluster has the following characteristic
1) 2 nodes at both the primary and remote site
2) 60 TB of storage on each node
3) 1.9 TB SSD disks in each node
4) 8 VMs per protection domain
5) A mix of ESXi and AHV hypervisor
What three steps would need to be taken successfully enable Near Sync? (Choose Three)
1) 2 nodes at both the primary and remote site
2) 60 TB of storage on each node
3) 1.9 TB SSD disks in each node
4) 8 VMs per protection domain
5) A mix of ESXi and AHV hypervisor
What three steps would need to be taken successfully enable Near Sync? (Choose Three)
NCP-MCI-5.15 Exam Question 23
An administrator logs in to Prism Element goes to the Network view, and sees the output shown in the exhibit.

Which three steps must the administrator take to increase throughput to the host? (Choose three.)

Which three steps must the administrator take to increase throughput to the host? (Choose three.)
NCP-MCI-5.15 Exam Question 24
A customer has a newly-deployed AHV cluster with nodes that have 2.x 10 GBE and 2.x interface. The customer wants to use all available network interfaces to provide connectivity to the VMs.
Which option should the administrator use to achieve this while remaining consistent with Nutanix recommendations?
Which option should the administrator use to achieve this while remaining consistent with Nutanix recommendations?
NCP-MCI-5.15 Exam Question 25
An administrator needs to replace the default self-signed certificate in Prism with a certificate signed by a trusted Certificate Authority (CA).
Which option on the task menu should the administrator select to change this configuration?
Which option on the task menu should the administrator select to change this configuration?