In Nutanix Prism Central, if anadministrator is also an approverfor an approval policy, it can result in repeated prompts for approvals even after the original request is approved. This occurs because the system requires the approver (who is also the requester) to explicitly confirm actions involving protected snapshots to maintain compliance and avoid accidental deletion.
From theNutanix ECA documentation:
"When an administrator is configured as an approver in the approval policy, repeated approval requests may occur because the same user must explicitly confirm actions they initiated, such as deleting protected snapshots. This ensures administrative actions are fully deliberate."

Nutanix AHV networking supports multiple bond types that determine how traffic is distributed across physical NICs. The detailed guidance in the AHV networking section states:
"Active-Active bonding provides load distribution of outbound traffic across all interfaces in the bond, allowing aggregate throughput beyond a single physical adapter." Active-backup keeps only one NIC active at a time and provides no throughput gain. Active-Active with MAC pinning distributes VMs across NICs but does not aggregate the total throughput for a single VM and is typically used with switch-independent designs.
Because the requirement is to "take advantage of bandwidth beyond a single adapter," only the standard Active-Active bond type satisfies this, as it truly aggregates available bandwidth.
Therefore, the correct bond type is Active-Active.

CPU Ready Time indicates how long a VM waits for CPU resources due to contention.
* Option B (Review host CPU utilization) is correct:
* IfCPU utilization is high, there may beexcessive CPU overcommitment, leading to high CPU Ready Time.
* Adding more hostsorreducing vCPU allocationsmay resolve the issue.
* Option A (Check CVM vCPUs) is incorrect:
* The Controller VM (CVM)does not directly impact application VM performancein this case.
* Option C (Assess SSD capacity) is incorrect:
* CPU Ready Time is unrelated to storage performance.
* Option D (Enable VM memory oversubscription) is incorrect:
* Memory oversubscription does not affect CPU contention.
References:
Nutanix Prism Central Guide #Troubleshooting VM Performance
Nutanix KB #Identifying High CPU Ready Time and Solutions

When creating a storage container in Nutanix, the administrator must configure the correctcapacity settings:
* Option A (Prism Element with Advertised Capacity of 100 GiB) is correct:
* Advertised Capacitydefineslogical limitsfor the container (i.e., how much space it reports as available).
* Inline Compressioncan be enabled directly in Prism Element.
* Option B (Create in Prism Element without Advertised Capacity)is incorrect:
* Without specifyingAdvertised Capacity, the container may consume unlimited storage.
* Option C (Create in Prism Central with Reserved Capacity)is incorrect:
* Reserved Capacityapplies toQuality of Service (QoS) policies, not storage limits.
* Option D (Create in Prism Central without capacity limits)is incorrect:
* Prism Central can manage storage but does not directly enforceRF1 and compression policies.
References:
Nutanix Storage Management Guide #Creating and Managing Storage Containers Nutanix Bible #Replication Factor (RF) and Data Optimization Nutanix KB #Inline Compression Best Practices in Nutanix AOS