https://docs.paloaltonetworks.com/pan-os/10-2/pan-os-admin/high-availability/set-up-activeactive-ha/prerequisites-for-activeactive-ha These are the two links that can be used to configure an active/active high availability pair. An active/active high availability pair consists of two firewalls that are both active and share the traffic load between them1. To configure an active/active high availability pair, the following links are required2:
HA1: This is the control link that is used for exchanging heartbeat messages and configuration synchronization between the firewalls. It can be a dedicated interface or a subinterface. It can also have a backup link for redundancy.
HA2: This is the data link that is used for forwarding sessions from one firewall to another in case of failover or load balancing. It can be a dedicated interface or a subinterface. It can also have a backup link for redundancy.
HA3: This is the session owner synchronization link that is used for synchronizing session information between the firewalls in different virtual systems. It can be a dedicated interface or a subinterface. It is only required for active/active high availability pairs, not for active/passive pairs.

The GlobalProtect VPN solution by Palo Alto Networks is designed to provide secure remote access to users. It primarily attempts to establish a VPN tunnel using the IPSec protocol for optimal security and performance. However, in cases where IPSec cannot be used due to network restrictions or other issues, GlobalProtect has a fallback mechanism.
C . It tries to establish a tunnel to the GlobalProtect gateway using SSL/TLS:
If the GlobalProtect app fails to establish an IPSec tunnel with the GlobalProtect gateway, the default behavior is to fallback to SSL/TLS for tunnel establishment. This ensures that the VPN connection can still be established, maintaining secure remote access for the user even in environments where IPSec is not feasible. SSL/TLS provides a secure tunnel, albeit generally with slightly less efficiency than IPSec.
This fallback mechanism is part of the GlobalProtect app's design to ensure reliability and continuous secure access for remote users under various network conditions.

In order to see what is in a template, the device-group needs the template referenced. Even if you add the firewall to both the template and device-group, the device-group will not see what is in the template. The following link has a video that demonstrates that B is the correct answer. https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000PNfeCAG