A.Compares the management plane configuration states containing control plane traffic and error reporting from transport node agents.

B.Injects synthetic traffic into the data plane and observes the results in the control plane.

C.Injects ICMP traffic into the data plane and observes the results in the control plane.

D.Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.

A.VLAN Uplink
"The service interface is a special-purpose port to enable services for mainly VLAN-based networks. North-south service insertion is another use case that requires a service interface to connect a partner appliance and redirect north-south traffic for partner services. Service interfaces are supported on both active-standby Tier-0 logical routers and Tier-1 routers. Firewall, NAT, and VPNs are supported on this interface. The service interface is also a downlink"

B.Loopback Router Port

C.Service interface

D.Downlink interface

A.Tier-1 Gateway

B.Layer 2 Gateway

C.Edge Services Gateway

D.Tier-0 Gateway

A.can have a maximum of 8 edge nodes

B.must have only active-active edge nodes

C.can have a maximum of 10 edge nodes

D.can contain multiple types of edge nodes (VM or bare metal)

E.must contain only one type of edge nodes (VM or bare metal)

A.set cli-timeout 1

B.set cli-timeout 0

C.set cli-timeout enabled

D.set cli-timeout disabled