Online Access Free CQI Exam Questions

An inspector wishes to determine the frequency of defects that have been found during the inspection of a specific part in order to set priorities for resolution. The attribute data could best be evaluated using which of the following?
Response:

• A.A run chart
• B.A scatter diagram
• C.A Pareto chart
• D.A histogram

Geometric dimensioning and tolerancing defines a basic dimension as:
Response:

• A.a numerical value used to describe the theoretically exact size, profile orientation, or location of a feature or datum target.
• B.dimension, usually without tolerance, used for information purposes only.
• C.the general term applied to a physical portion of a part, such as a surface, pin, tab, hole, or slot.
• D.a numerical value expressed in appropriate units of measure and used to define the size, location, geometric characteristic, or surface texture of a part or part feature.

Which of the following is a method for determining behavior of materials under axial stretch loading?
Response:

• A.Hardness
• B.Tensile
• C.Metallography
• D.Force

Which of the following is not a typical problem of poor data collection?
Response:

• A.Inability to calculate descriptive statistics
• B.Inaccurate information to make appropriate decisions
• C.Inconsistencies in results across lots
• D.Difficulties in interpretation of the data

How many micro inches in 2.5 inches?
Response:

• A.25,000
• B.2,500
• C.25,000,000
• D.2,500,000