Online Access Free 3605 Exam Questions

A technician has implemented RSMLT edge design. After recovering from power outage some clients could not communicate. It has been stated that only one of the core RSMLT switches has recovered. What should have been done to prevent the loss of communications?

• A.Increase the hold up timer to 9999.
• B.Set the VLAN to copy RSMLT into from a similarity configured VLAN.
• C.Clear the peer IP and MAC addresses.
• D.Turn off the hold down timer.

An existing enterprise network is using Ethernet Routing Switch (ERS) 8600 switches in the campus core. It has been determined that 10 Gigabit links are required to replace the existing 1 gigabit uplinks will affect is connections on each of the ERS 8600 switches. Which statement describes how to accomplish this requirement in each ERS 8600 chassis?

• A.Replace the two existing switches fabric modules with 8394SF systems.
• B.Replace the two existing switch fabric modules with 8692SF and Supermez2
• C.Replace the six 8683XLK modules with 8612XLRS.
• D.Replace the two existing 8616SXE modules with 8612XLRS modules.

An Information Technology organization needs to
determine whether they should upgrade their existing Routing Switch (ERS) 8600 switches to release 5.0. Each chassis currently has both 8648GTR 8648TX modules. One of the features that the company requires is the ability to perform port mirroring on multiple ports per module
at a time.
What
should be done to meet
their port mirroring requirement when upgrading to software release 5.0?

• A.Upgrade to ERS 8600 Release 5.0 without any hardware upgrade.
• B.Replace the existing
  8648TX modules
  with ERS 8648TXE
  for egress mirroring.
• C.Recommend other means to capturing traffic.
• D.Replace the existing modules with 8648GTRS modules,

What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?

• A.16
• B.50
• C.48
• D.24

Which set of procedures will upgrade the boot monitor on an Ethernet Routing Switch (ERS) 8600 with a single 8692SF module?

• A.Copy the new image to flash. Modify the boot choice for run-time image. Boot the new image.
• B.Copy the new image to flash. Activate the new image with SF module in service.
• C.Copy the new image to flash. Modify the boot choice for run-time change. Activate the new image SF module in service.
• D.Copy the new image to flash. Boot the new image.