Online Access Free 6101-1 Exam Questions

A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available.
Which statement is correct?

• A.The customer can set the switch to use the temporary address of 192.168.192.168 by pressing the User Interface button on the front of the ERS 2550T
• B.The switch will first attempt to use BootP to acquire an IP address, and if that fails it will assign IP address 192.160.1.1/24 to the switch IP.
• C.The customer can connect to the network management Ethernet port which is pre-configured to use the 192 168 1 1/24 IP address
• D.To communicate with an ERS 2550T the IP address must first be set though the console interface.

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green
What is the status of the port?

• A.The link speed is 100 Mbps. and the port is disabled.
• B.The link speed is 1000 Mbps. and the port is passing traffic.
• C.The link speed is 1000 Mbps, and the port is disabled
• D.The link speed is 100 Mbps. and the port is passing traffic.

A technician is configuring an Ethernet routing switch (ERS)-24T-PWR, and to add ports 10 through 20 to VLAN 100.
Which ACLI command is used to accomplish this task?

• A.5520-24-PWR (config) # vlan members add 100 10-20
• B.5520-24-PWR (config-if) #vlan 100 add members 10-20
• C.5520-24-PWR (config-vlan) # members add 100 10-20
• D.5520-24-PWR (config) # vlan 100 add members 10-20

What is a characteristic of Routed Split Multilink Trunking (RSMLT) configuration?

• A.RSMLT routers are implemented with VRF-Lite routers.
• B.RSMLT is always used in conjunction with routing protocols and SMLT connections.
• C.RSMLT uses priority values to distinguish between the primary and backup routers.
• D.RSMLT is only configured on edge SMLT connections.

For a Converged Campus network, which configuration change is recommended for the default VLAN (VLAN 1)?

• A.Assign an IP address to the default VLAN for switch management
• B.Remove the default VLAN from active ports.
• C.Remove spanning tree from the default VLAN
• D.Configure QoS on the default VLAN to support voice traffic.