Online Access Free 6101.1 Exam Questions

After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST
What are two causes of the IST not running properly? (Choose two)

• A.The IST is not enabled on both switches.
• B.The MLT ID does not match on both switches.
• C.The peer IP address is not the address of the peer switch IST VLAN.
• D.The peer IP addresses have to be 192.168.1.1/30 and 192.168.1.2/30.

A technician has installed a license file on the Ethernet routing switch (ERS) 8800 and rebooted, but cannot configure the associated licensed features. it has been determined that license did not load properly at booyup time.
Which two must be verified?

• A.The appropriate license level has been obtained.
• B.The switch is at the current release.
• C.The license file has .dat extension.
• D.The license file is stored in the flash directory
• E.The license filename contains valid characters.

An Ethernet Routing Switch (ERS) 8600 for Virtual Router Redundancy Protocol (VRRP) is being configured. Which CU command would cause this switch to be the VRRP master?

• A.ERS8600:5# config vlan 100 ip vrrp 100 priority 250
• B.ERS8600:5# config vlan 100 ip vrrp 100 priority master
• C.ERS8600:5ff config vlan l00 ip vrrp 100 priority 1
• D.ERS860Q:5# config vlan 100 ip vrrp 100 master

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast
-
Sparse Mode (PIM-SM) Which licensing requirement applies?

• A.the PIM-SM con only be licensed on ERS 5510 models
• B.the PIM-SM is already covered by the existing advanced feature license
• C.A Premier license is needed
• D.the PIM-SM is included m the base license with release 6.2

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop.
What are two reasons this occurred? (Choose two)

• A.Extended CP limit on the transmitting port was not configured.
• B.the VLAN where the loop originated to the SLPP transmitting list was not added.
• C.A premier License for SLPP is needed.
• D.SLPP was not globally enabled