Online Access Free 76940X Exam Questions

A support engineer logs into Avaya Orchestrator and clicks on the Service Availability icon for the Power Supply of a G450 device.
What information is the engineer looking for?

• A.A percentage breakdown of the state of the power supply (OK, Warning, Unknown or Critical) over a period of time.
• B.The current state of the power supply (OK, Warning, Unknown or Critical).
• C.A list of other services that are available for the G450 device.
• D.The amount power (in Watts) that the power supply is using.

You notice that Orchestrator is unable to automatically discover a new HP DL360 G10 Server that has been added to the ACP.
What could be causing this problem?

• A.Orchestrator's auto-discovery schedule has been left disabled by default.
• B.The Server has not been configured to send SNMP traps and Syslog messages to Orchestrator.
• C.This is expected as Orchestrator does not automatically discover new devices.
• D.The Server's firmware has not been patched with the HotFix needed to reply to Orchestrator's discovery messages.

A support engineer is upgrading a PodFX 3.1 system to ACP 4200 4.0. The system has two pairs of ServerTech PDUs.
Which statement about the PDU firmware file describes the upgrade process that the engineer needs to follow?

• A.It will need to be uploaded to all 4 PDUs.
• B.It will need to be uploaded to one PDU. This PDU will then distribute the file to the remaining 3 PDUs.
• C.It will need to be uploaded to each PDU Management Web Interface.
• D.It will need to be uploaded to Orchestrator. Orchestrator will then distribute the file to the 4 PDUs.

When deploying the vCenter update, there are certain parameters that must be used.
Which IP address should be used for the Network 1 IP Address?

• A.The datacenter facing IP interface IP address and a 32 bit mask
• B.The Localhost IP address for your datacenter subnet IP interface
• C.A temporary IP, from the Management subnet, not already in use
• D.The Internet facing IP interface IP address and mask

A maintenance window had been scheduled to allow for the upgrade of the firmware of one of the VSP switches in the ACP. However, steps were not taken to avoid receiving unnecessary notifications during this period. As a result, when the upgrade process started the VSP switch shows multiple critical alerts.
At this point, what would a support engineer do to reduce the amount of these unwanted alerts?

• A.The engineer will have to wait for the upgrade process to complete.
• B.Use the Recurring Downtime feature in Orchestrator.
• C.Use the Post-Event Downtime feature in Orchestrator.
• D.Use the Mass Acknowledgments feature in Orchestrator.