Online Access Free 150-810 Exam Questions

An FCoE device is unable to log in to a Brocade VDX 8770.What are two reasons for this happening? (Choose two)

• A.Required TLVs have not been advertised under LLDP.
• B.The default FCoE map has not been applied to the interface.
• C.An FCoE map has not been configured.
• D.The port or LLDP has been correctly configured but should be enabled in NOS.

Which two statements are correct about VRRP and VRRP-E? (Choose two)

• A.When using VRRP, all peers are backups.
• B.Short-path forwarding is enabled by default on VRRP peers and must be explicitly enabled onVRRP-E configurations.
• C.When using VRRP-E and the master router fails, you are able to ping the virtual IP address.
• D.VRRP may be configured on all interfaces, but VRRP-E may only be configured on VE interfaces.

You are trying to configure a vLAG using two Brocade VDX switches and it is not forming properly.
What are two reasons for this happening? (Choose two)

• A.There is no connectivity between the VCS fabric switches.
• B.The vLAG is configured as active on the VCS switches and passive on the device at the other end.
• C.The vLAG is configured as standard on the VCS switches and standard on the device at the other end.
• D.Port-channel numbers configured on the VCS switches do not match.

Referring to the exhibit, which two ports will be blocked by ACL20? (Choose two)

• A.UDP port 5 traffic
• B.TCP port 15 traffic
• C.TCP port 80 traffic
• D.UDP port 15 traffic

You are troubleshooting an existing LAG.After issuing clearLacp counters, you observe the output shown in the exhibit.What is the problem?

• A.An upstream switch is flooding LACPDUs on port channel 10.
• B.The VDX is not transmitting LACPDUs.
• C.An upstream switch is not transmitting LACPDUs.
• D.The VDX is not marking LACPDUs on port channel 10.