Online Access Free CAT-540 Exam Questions

If a new hub is installed on the same network as the primary hub and the new hub is not appearing in the CA UIM GUIs, which troubleshooting steps are needed? (Choose two.)

• A.On the primary hub and on the new hub, check the robot.cfg and hub.cfg files and make sure the domain is exactly the same.
• B.Ensure that all hub IP addresses are in a common host file.
• C.On the hub GUI, on the Name Services tab, set up the named IP.
• D.Configure DNS reverse lookup.

Which version of Java must be installed before you can install CA UIM?

• A.JRE 1.8
• B.Host JRE is not a prerequisite for installation of UIM
• C.Any version
• D.JRE 1.7

You can save time during robot deployment by using an answer file, which can be used with the CA UIM native installer or third-party tools.
Which variables are REQUIRED in the answer file? (Choose four.)

• A.robotip
• B.hub
• C.hubip
• D.domain
• E.hubrobotname

By default, the CA UIM VMware probe gets the VM name instead of the host name of the VM guest. Because any name can be used for the VM name, this can lead to inconsistent data. Therefore, when you configure the VMware probe, you need to force it to use the host name of the VM guest for UIM inventory population. How is this accomplished? (Choose two.)

• A.Ensure that VMware Tools is installed on each guest VM.
• B.Ensure that the cdm probe is deployed to all guest VMs.
• C.Configure "use_guest_name_for_source = yes".
• D.Configure "show_vmname = no".

In CA UIM 8.5.1. which probes are covered by Monitoring Configuration Service (MCS) templates? (Choose three.)

• A.vmax
• B.vmware
• C.cdm and ntevl
• D.snmpcollector
• E.dirscan