A Reassociation Request frame is sent every time a STA roams from one AP to another within the same ESS. A Reassociation Request frame is similar to an Association Request frame, but it also contains the BSSID of the current AP that the STA is leaving. This allows the new AP to coordinate with the old AP and transfer the STA's context information, such as security keys, QoS parameters, and buffered frames. This way, the STA can maintain its connectivity and session continuity during roaming.

The function of the PHY preamble is to allow the receiver to detect and synchronize with the signal. The PHY preamble is a part of the PPDU that is transmitted before the PHY header and the PSDU. The PHY preamble consists of a series of training fields that help the receiver to adjust its parameters, such as frequency, timing, and gain, to match the incoming signal. The PHY preamble also helps the receiver to estimate the channel conditions and noise level.

Explanation
One of the information that is communicated by bits in the PHY header is data rate. Data rate is the speed at which data is transmitted or received over the wireless medium. Data rate depends on factors such as modulation, coding, channel width, spatial streams, and guard interval. Data rate is indicated by bits in different fields of the PHY header, depending on the type of PPDU (e.g., OFDM, HT, VHT, HE). The receiver uses these bits to determine how to decode and demodulate the rest of the PPDU. The other options are not correct, as they are not communicated by bits in the PHY header. SNR (Signal-to-Noise Ratio), noise, and signal strengthare measured by the receiver based on its own capabilities and environment. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 4: 802.11 Physical Layer, page 101-105

In the 2.4 GHz band, probe requests are usually sent at the minimum basic rate from an unassociated STA. A probe request is a type of management frame that is transmitted by a STA to discover available BSSs in its vicinity. A probe request can be sent on one or more channels in either passive or active scanning mode. In passive scanning mode, a STA listens for beacon frames from APs on each channel. In active scanning mode, a STA sends probe requests on each channel and waits for probe responses from APs. A probe request is usually sent at the minimum basic rate, which is the lowest data rate among the supported rates that is required for all STAs to join and communicate with a BSS. The minimum basic rate can vary depending on the configuration of each BSS, but it is typically one of these values: 1 Mbps, 2 Mbps, 5.5 Mbps, or 11 Mbps in the 2.4 GHz band. The other options are not correct, as they do not reflect how probe requests are usually sent in the 2.4 GHz band. MCS 0 is a modulation and coding scheme used by 802.11n/ac devices in either band, but it is not a data rate per se. 6 Mbps is a data rate used by OFDM devices in either band, but it is not usually configured as a minimum basic rate in the 2.4 GHz band.