A PS-Poll (Power Save Poll) frame is not an 802.11 management frame. A PS-Poll frame is a type of control frame that is used by a STA in power save mode to request data frames from an AP. A STA in power save mode can conserve battery power by periodically sleeping and waking up. When a STA sleeps, it cannot receive any data frames from the AP, so it informs the AP of its power save status by setting a bit in its MAC header. The AP then buffers any data frames destined for the sleeping STA until it wakes up. When a STA wakes up, it sends a PS-Poll frame to the AP, indicating its association ID and requesting any buffered data frames. The AP then responds with one or more data frames, followed by an ACK or BA frame from the STA. The other options are not correct, as they are types of 802.11 management frames. An Action frame is used to perform various management actions, such as spectrum management, QoS management, radio measurement, etc. A Beacon frame is used to advertise the presence and capabilities of an AP or BSS. An Authentication frame is used to establish or terminate an authentication relationship between a STA and an AP. References: [Wireless Analysis Professional Study Guide CWAP-405], Chapter 6: 802.11 Frame Exchanges, page 169-170

A very common problem for WLANs is DHCP pool depletion. This occurs because many wireless clients come-and-go from the network quickly. If a client connects for only two or three minutes and the lease duration is set to multiple days (3-8 days is not uncommon), the IP address will be lost for that entire time. To resolve such issues, create more pools and reduce the lease duration to hours instead of days. Look for DHCP negative acknowledgement or server log errors to determine if the IP pool is depleted.

References:

The data rate at which the PHY preamble was transmitted is 6 Mbps. The PHY preamble is a part of the PPDU that is transmitted before the PHY header and the PSDU. The PHY preamble consists of a series of training fields that help the receiver to detect and synchronize with the signal. The PHY preamble is always transmitted at a fixed data rate that depends on the type of PPDU (e.g., OFDM, HT, VHT, HE). For an 802.1 lac data frame on channel 52, which uses VHT PPDUs, the data rate for the PHY preamble is 6 Mbps. This data rate does not depend on MCS (Modulation and Coding Scheme), which only affects the data rate for the PSDU. References: [Wireless Analysis Professional Study Guide CWAP-405], Chapter 4: 802.11 Physical Layer, page 99-100

An RTS (Request to Send) frame should be acknowledged by a CTS (Clear to Send) frame. An RTS and CTS frame are types of control frames that are used to implement a virtual carrier sense mechanism called RTS
/CTS. RTS/CTS is a technique that helps to avoid collisions and hidden node problems in wireless transmissions. When a STA (station) wants to send a data frame, it first sends an RTS frame to the intended receiver, indicating the duration of the transmission. The receiver then responds with a CTS frame, also indicating the duration of the transmission. The other STAs in the vicinity hear either the RTS or the CTS frame and update their NAV (Network Allocation Vector) timers accordingly, deferring their access to the medium until the transmission is over. The sender then sends the data frame, followed by an ACK (Acknowledgement) frame from the receiver. The other options are not correct, as they are not used to acknowledge an RTS frame. An ACK frame is used to acknowledge a data frame, not an RTS frame. An RTS- Ack frame does not exist, as there is no such type of control frame in 802.11. A Block Ack (BA) frame is used to acknowledge multiple data frames in a single frame, not an RTS frame. References: [Wireless Analysis Professional Study Guide CWAP-405], Chapter 6: 802.11 Frame Exchanges, page 166-167