The Group Key Handshake consists of two frames excluding any Ack frames that may be required. The Group Key Handshake is used to distribute and update the Group Temporal Key (GTK) for encrypting broadcast and multicast traffic. The AP initiates the Group Key Handshake by sending a Group Key Message
1 frame to a STA, which contains the new GTK and other information. The STA responds with a Group Key Message 2 frame to the AP, which confirms the receipt of the GTK and other information. After this, both the AP and the STA can use the new GTK for encryption and decryption of broadcast and multicast traffic .
References: CWAP-405Certified Wireless Analysis Professional Study and Reference Guide, Chapter 7:
802.11 Security, page 246; CWAP-405Certified Wireless Analysis Professional Study and Reference Guide, Chapter 7: 802.11 Security, page 247.

The most likely issue that can be identified from the spectrum analysis is a power mismatch between the APs and the clients. A power mismatch occurs when the APs transmit at a higher power level than the clients, or vice versa. This can cause asymmetric communication, where one side can hear the other, but not vice versa.
This can result in poor performance, disconnections, or packet loss. A spectrum analysis can reveal a power mismatch by showing different signal amplitudes or RSSI values for the APs and the clients on the same channel or frequency. The other options are not correct, as they cannot be identified from the spectrum analysis alone. The tablets' SSID, power save mode, and noise floor can be determined by using other tools or methods, such as protocol analysis, site survey, or device configuration. References: [Wireless Analysis Professional Study Guide CWAP-405], Chapter 3: Spectrum Analysis, page 79-80

Display filters are applied after the capture is completed and they only hide the packets from view. The filtered packets are still present in the capture file and can be enabled for view later by changing or removing the display filter. This is an advantage over capture-time filters, which discard the packets that do not match the filter criteria and cannot be recovered later34 References:
* CWAP-403 Study Guide, Chapter 2: Protocol Analysis, page 37
* CWAP-403 Objectives, Section 2.3: Apply display filters

References: