Online Access Free CWDP-304 Exam Questions

During a validation site survey, you realize that the installers mounted some of the APs on the wait when the design called Tor a celling mount. They said that this was done because the cabling company did not have the right tools to run the cables above the ceiling. You know that this will cause a difference in how the Wi-Fi signal will radiate throughout the environment. What should you do in this case?

• A.Turn up the power on the APs to accommodate for the difference
• B.Blame the cabling company it the Wi-Fi doesn't work since they didnot do their job correctly
• C.Leave it as it is because it will not have a significant impact
• D.Advise the stakeholder that requirements will not be met and a new design process will be needed to meet the requirements

When selecting a centralized WLAN architecture, what new problem may arise when you change the data forwarding model from centralized to distributed?

• A.Centralized control functions, such as key management and distribution, RRM, and load balancing will no longer be supported.
• B.APs that were designed for a centralized forwarding model may not support all features in distributed forwarding mode.
• C.All RRM controls will also need to be distributed to a master AP that acts as a channel and transmit power arbiter for other APs in the ESS.
• D.The router between the APs and the controller must be made aware of the APs as forwarding client STAs.

Given: For this fill-in the blank question, each answer option contains an answer for the first and second blanks, separated by a dash "-". Choose the answer option that correctly fills in both blanks in the following sentence.
A WLAN may use 802.11 admission control to ________, and admission control requirements are configured separately for each ________.

• A.Block stations with inadequate security parameters - SSID
• B.Mark ingress and egress frames with priority values - TCP/IP port
• C.Identify voice-enabled wireless devices - AP radio (that is, 2.4 GHz or 5 GHz)
• D.Regulate the available bandwidth resources - Access Category

You have been tasked with performing safety and operations training for outdoor bridge link installation. The antennas are to be installed on a 70-foot tower on one end and the roof top of an office building on the other end.
What might be required for the tower installation?
Response:

• A.APs that are designed to operate above 70 feet.
• B.Special antennas that avoid reflections on the tower poles.
• C.Special RF cables that will not create loss incurred by the metal tower construction.
• D.Hiring a certified tower installer.

An amplifier has a 1 dB compression point of 32 dBm and a gain of 20 dB. Which is the highest average input power shown here that would be safe to operate a 24 Mbps 802.11g signal so that spectral regrowth is not a problem?
Response:

• A.5 dBm
• B.#5 dBm
• C.0 dBm
• D.10 dBm