Online Access Free 200-001 Exam Questions

Which two of these support an ad-hoc conference call? (Choose two.)

• A.using the tab Administrative Tools > Configuration > Conference Settings in the Cisco TelePresence Management Suite
• B.pressing the conference button on a Cisco Unified IP Phone 8941 to conference in a third call
• C.Cisco TelePresence Multiway with Cisco TelePresence Multipoint Control Unit and Cisco TelePresence Video Communications Server
• D.using the Booking tab in the Cisco TelePresence Management Suite to configure a new conference
• E.using the Cisco TelePresence Management Suite Scheduler to schedule a conference call to
  start in 5 minutes

Which CLI command can be used to reset the Cisco TelePresence System 500-32 personal video system to a factory condition?

• A.utils reset factory
• B.utils system factory init
• C.utils factory reset 2
• D.xcommand SystemUnit FactoryReset
• E.xcommand defaultvalues set level: 2
• F.xconfiguration default factory

Your customer reports that new A/V equipment that plays movies cannot be displayed on their Cisco TelePresence endpoints. This A/V equipment is connected to the Cisco TelePresence codec via an HDMI cable. However, older A/V gear that uses composite cables is able to display content. What is most likely the cause of this issue?

• A.TIP negotiation is failing between the A/V gear and the Cisco TelePresence device.
• B.The operating system for the A/V gear is not compatible with the operating system of the Cisco TelePresence device.
• C.The A/V gear is using HDCP to prevent illegal copying.
• D.The composite cables are faulty.

Refer to the exhibit.

Users in a Cisco TelePresence room report audio and video quality issues. You have been asked to troubleshoot the issue. You log in to the endpoint GUI and check telephony settings. Which
option would you recommend to resolve the issue?

• A.DSCP values are correct. Check the QoS configuration on the router.
• B."DSCP For TelePresence" is not correct. Configure the correct value via codec GUI.
• C.The "DSCP For TelePresence" and "DSCP For Audio" values are not correct. Configure the correct value in codec GUI.
• D.The "DSCP For TelePresence" and "DSCP For Audio" values are not correct. Configure the correct value in the Cisco Unified Communications Manager service parameter.
• E."DSCP For Audio" is not correct. Configure the correct value via codec GUI.
• F.Audio/video quality issues are generally due to low bandwidth. Contact your carrier to increase the bandwidth.

Which component of the Cisco TelePresence multipoint media infrastructure is intended for use only with non-immersive endpoints?

• A.Cisco TelePresence Multipoint Switch
• B.Cisco TelePresence Multipoint Control Unit
• C.Cisco TelePresence System 500-32
• D.Cisco TelePresence Server