Online Access Free Cisco.200-101.v2021-12-02.q60 Practice Test (Page 12)

200-101 Exam Question 51

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

A.Interface S0/0 on RouterA is configured with an incorrect subnet mask.

B.Interface S0/0 on RouterB is administratively down.

C.The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.

D.The IP address that is configured on S0/0 of RouterB is not in the correct subnet.

E.Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

F.The cable that is connected to S0/0 on RouterA is faulty.

200-101 Exam Question 52

Which three statements about RSTP are true? (Choose three.)

A.RSTP significantly reduces topology reconverging time after a link failure.

B.RSTP port states are blocking, discarding, learning, or forwarding.

C.RSTP also uses the STP proposal-agreement sequence.

D.RSTP uses the same timer-based process as STP on point-to-point links.

E.RSTP expands the STP port roles by adding the alternate and backup roles.

F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.

200-101 Exam Question 53

Refer to the exhibit.

Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?

A.The router will forward packets from R3 to R2 to R1.

B.The router will forward packets from R3 to R1 to R2.

C.The router will forward packets from R3 to R2 to R1 AND from R3 to R1.

D.The router will forward packets from R3 to R1.

200-101 Exam Question 54

Refer to the exhibit.

A network associate has configured OSPF with the command:
City(config-router)# network 192.168.12.64 0.0.0.63 area 0
After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? (Choose three.)

A.FastEthernet0 /0

B.FastEthernet0 /1

C.Serial0/0

D.Serial0/1.102

E.Serial0/1.103

F.Serial0/1.104

200-101 Exam Question 55

It has become necessary to configure an existing serial interface to accept a second Frame Relay virtual circuit. Which of the following are required to solve this? (Choose three)

A.configure static frame relay map entries for each subinterface network.

B.remove the ip address from the physical interface

C.create the virtual interfaces with the interface command

D.configure each subinterface with its own IP address

E.disable split horizon to prevent routing loops between the subinterface networks

F.encapsulate the physical interface with multipoint PPP

Other Version: 1356Cisco.200-101.v2022-02-14.q60; 49Cisco.Pass4leader.200-101.v2022-02-05.by.wallis.60q.pdf; 70Cisco.Actual4labs.200-101.v2021-08-23.by.ivy.65q.pdf

Latest Upload: 119SAP.C_BCBAI_2509.v2026-01-15.q13; 209DAMA.DMF-1220.v2026-01-15.q271; 138SAP.C_SIGDA_2403.v2026-01-15.q66; 203ISACA.CRISC.v2026-01-15.q649; 128PaloAltoNetworks.NetSec-Pro.v2026-01-15.q26; 170Splunk.SPLK-1002.v2026-01-14.q121; 170EMC.NCP-AII.v2026-01-14.q144; 164Microsoft.AZ-800.v2026-01-13.q144; 176Microsoft.MS-102.v2026-01-13.q258; 121HP.HPE2-E84.v2026-01-13.q17

200-101 Exam Question 51

200-101 Exam Question 52

200-101 Exam Question 53

200-101 Exam Question 54

200-101 Exam Question 55

Download PDF File