Online Access Free 200-401 Exam Questions

An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is turned on and the switch port link LED turns green. The link light indicates what two conditions? (Choose two.)

• A.The Layer 1 media is functioning between the PC and switch.
• B.If flashing, the green LED indicates port speed of 100 Mb/s.
• C.The switch port is functioning as a half-duplex connection.
• D.Traffic is being sent from the switch to the P
• E.Layer 2 communication has been established between the PC and switch.
• F.The PC has received a DHCP address.

What are two benefits of a star network topology? (Choose two.)

• A.Any problem which leaves the network inoperable can be traced to the central hub.
• B.The performance of the entire network is directly dependent on the performance of the hub.
• C.This network type requires less cable as compared to linear bus topology.
• D.The performance of one of the numerous nodes cannot reflect on the performance of other nodes.
• E.Disruption of the entire network is not required when adding new machines.

Exhibit:

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B.
Which address is the default gateway of Host 3?

• A.the address of the host that is connected to Network B
• B.the address of the switch interface that is connected to router interface Fa0/0
• C.the address of the host that is connected to Network A
• D.the address of the router interface Fa0/0
• E.the address of the switch interface that is connected to router interface Fa0/1
• F.the address of the router interface Fa0/1

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

• A.Use the switchport protected command to have the MAC addresses added to the configuration.
• B.Set the switchport mode to trunk and save the running configuration.
• C.Enable port security and use the keyword sticky.
• D.Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

With a Cisco IE 2000 switch, what does a port status LED indicate when it is solid amber?

• A.A link is present.
• B.The port is not forwarding.
• C.No link is present.
• D.The port is sending or receiving data.
• E.There is a link fault.