Online Access Free 300-115 Exam Questions

Which option is the value of the Tag Protocol Identifier for an 802 1Q tagged frame?

• A.0x0800
• B.0x8100
• C.0x0806
• D.0x888E

Which two statements about default FHRP behavior are true? (Choose two)

• A.A backup GLBP active virtual gateway can become active only if the current active virtual gateway fails.
• B.A standby HSRP router becomes active if it has a higher priority than the priority of the current active router.
• C.A VRRP backup virtual router becomes the master router if its priority is higher than the priority of the current master router.
• D.Preemption is enabled by default.
• E.Unless specifically Configured, the priority of an HSRP router is 200.

Refer to the exhibit.

An engineer is configuring a trunking port-channel between Switch 1 and Switch 2 and receives an error message on Switch 1. Which action corrects this error?

• A.enabling BPDU guard on interface Fa0/23 of Switch 1
• B.disabling BPDU guard on interface Fa0/23 of Switch 1
• C.enabling BPDU guard on interface Fa0/23 of Switch 2
• D.disabling BPDU guard on interface Fa0/23 of Switch 2

Refer to the exhibit.

Which path does PC1 take to reach DSW1?

• A.PC1 goes from ALSW1 to reach DSW1
• B.PC1 goes from ALSW1 to DSW2 to ALSW2 to reach DSW1
• C.PC1 goes from ALSW1 to DSW2 to reach DSW1
• D.PC1 goes from ALSW1 to ALSW2 to reach DSW1
• E.PC1 goes from ALSW1 to DSW2 to CORE to reach DSW1

Refer to Exhibit.

You have applied these configurations to switches A, B, C and D respectively and the switches are connected to one another on a trunk port that is passing all VLAN traffic. Which statements about traffic on the network is true?

• A.Hosts on all four switches can communicate normally with one another over the trunk port.
• B.Unless a Layer 3 device is installed, hots on any of the switches will be able to communicate only with other hosts on the same switch.
• C.Hosts on all four switches can communicate normally with one another on VLAN 10 only.
• D.Unless a Layer 3 device in installed, hosts on the FastEthernet 0/1 interface of switch D will be unable to communicate with hosts on the other switches.