Online Access Free 300-320 Exam Questions

Refer to the exhibit.

An engineer has been asked to configure R3 as an OSPF ABR .Which configuration can be applied between the R1 and R3 nodes to accomplish this requirement?

• A.virtual-link in area 100.
• B.sham-link in area 100.
• C.sham-link in area 10.
• D.virtual-link in area 10.

Cisco FabricPath brings the benefits of routing protocols to Layer 2 network Ethernet environments.
What are two advantages of using Cisco FabricPath technology? (Choose two.)

• A.Cisco FabricPath provides MAC address scalability with conversational learning.
• B.Loop mitigation is provided by the TTL field in the frame.
• C.Cisco FabricPath technology is supported all Cisco platforms and can replace legacy Ethernet in all campus networks.
• D.Cisco FabricPath brings the benefits of routing protocols to Layer 2 network Ethernet environments.
• E.Cisco FabricPath relies on OSPF to support Layer 2 forwarding between switches, which allows load balancing between redundant paths.

What are the two main elements used by RBAC to provide secure access within an Enterprise? (Choose two.)

• A.User Profile
• B.User Roles
• C.User Domains
• D.User Privileges
• E.User Locales

Which technology should a network designer combine with VSS to ensure a loop free topology with optimal convergence time?

• A.UplinkFast
• B.Portfast
• C.RPVST+
• D.Multichassis EtherChannel

A Layer 3 link is used to connect two aggregation layer switches. Which kind of access layer topology design allows lot all access to aggregation uplinks to be active, but still have a backup in an uplink failure scenario?

• A.triangle looped
• B.square looped
• C.loop-free U
• D.loop-free inverted