Online Access Free 300-365 Exam Questions

An engineer has enabled Cisco Centralized Key Management on a WLAN with local and FlexConnect mode APs. The engineer notices that Cisco CKM is not working for theFlexConnect APs when looking at roaming, but is working for local mode APs. Which change is needed on the controller for Cisco CKM to work for the FlexConnect APs?

• A.Use local authentication.
• B.Enable FlexConnect Central Assoc.
• C.Place APs in FlexConnect group.
• D.Configure VLAN-based central switching.

Which standard specifies TSPEC to provide the management link between higher QoS protocols and the channel access function?

• A.802.11ac
• B.802.11af
• C.802.11e
• D.802.11a

A customer is concerned that the mesh network will not converge quickly enough because of the 20 percent premium that is given to the selected parent. What is the purpose of the premium?

• A.It prevents link flapping.
• B.Itspeeds up convergence.
• C.It uses SNR, regardless of the premium.
• D.It creates a list of other potential parents.

A customer recently implemented WLC wireless multicast. Clients and connecting at the highestmandatory wireless rate of 24 Mbps and are receiving multicasttraffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three)

• A.verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller's management VLAN
• B.verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
• C.verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients.
• D.change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
• E.make sure the highest mandatory rate is set to 54 Mbps so thatthe multicast traffic has sufficient bandwidth
• F.verify that Global Multicast mode has been enabled

An engineer must implement WLC features that enhance roaming. Which two technologies fulfill this requirement? (Choose two.)

• A.802.11X
• B.802.11v
• C.Cisco Centralized Key Management
• D.802.11r
• E.WPA2