Online Access Free 300-370 Exam Questions

Scenario
The big Engineering IT team has been in the lab to test some new features that the existing network does not support. The AP Groups, AP Failover, and Local Web Auth features are having problems. In this test environment, the controllers support the only Composite Structural Engineering and Aerodynamic Engineering groups. All SSIDs must omit the department name.
Refer to the exhibit. The diagram is the floor plan for the Big Engineering office and the distribution of the departments. These tables show how the controllers have been configured.
Note, not all menu items, text boxes, or radio buttons are active.

BE-GA
Controller Management Interfaces

Composite and Structural Engineering (CSE)
WLANs

AP Groups-CSE-WLANs

AE-User Names and Passwords

You review the configuration of the test network controller. Which four changes must be made to resolve the problems? (Choose four.) When you review the configuration of the test network controller what needs to be changed to resolve the problems? (Choose four.)

• A.Remove the current WLANs and replace them with WLANs that have the same SSID names as on the AE-2504A controller.
• B.Remove me current WLAN from the CSE-WLAN AP Group and add all three of the WLANs configured in the CSE-2504A
• C.Add the CSE APs to the CSE-WLANs AP-Group.
• D.Change the High Availability Primary Controller Management Interface IP address.
• E.Add the Local Net User names and passwords
• F.Change the Layer 2 security to none and Layer 3 Security to Web Policy for the CSE-Contractors WLAN

Two 5508 Wireless Lan Controllers are managing all Access Points throughout the network The WLCs are located in different locations to provide geographical redundancy A Mobility Group has been configured on both WLCs and has a UP status on both Controllers The APs m location A are statically configured to use Controller A as the Primary and Controller B as the Secondary If the WLC in location A goes offline, the APs successfully join the WLC m location B but they do not failover to their Primary configured Controller What configuration task will fix this issue'

• A.Use DHCP Option 43 and specify WLC in location A as Primary.
• B.Change the AP Failover Priority to critical.
• C.Configure the WLC in location A as Primary using the CAPWAP AP Controller IP Address command on all the location A Access Points.
• D.Enable AP Fallback globally on the WLC.

Users report slow wireless speeds in a facility where RRM settings are currently set at their default value and low data rates are disabled.
Which option is the cause for the poor performance seen by users?

• A.Event Driven RRM is interfering with proper RRM operation.
• B.802.11b data rates are enabled on all access points.
• C.All access points are on the same channel.
• D.Every channel in the 2.4 GHz network is enabled

Refer to the exhibit.

An engineer has determined that during a recent controller failure, some access points did not fail over to their secondary controller, which has sufficient licenses for all APs. The controllers are not in a mobility group, but have A records for their hostnames in DNS.
Using these high availability settings, which option is the most likely cause of this issue?

• A.DNS hostnames are required to be FQDN.
• B.The controllers must be in the same mobility group.
• C.The secondary controller IP address is incorrect.
• D.The AP failover priority was not set high enough.

A training class has 15 laptops connecting to the WLAN using the same Active Directory training credentials.
Users report that they cannot connect until someone else logs off. At any one time, only half of the class connect to the internet.
Which option must be checked first?

• A.Co-channel interference
• B.DHCP address pool
• C.Client Exclusion
• D.Maximum Allowed Clients