300-410 Exam Question 71
A CoPP policy is applied for receiving SSH traffic from the WAN interface on a Cisco ISR4321 router.
However, the SSH response from the router is abnormal and stuck during the high link utilization. The problem is identified as SSH traffic does not match in the ACL. Which action resolves the issue?
However, the SSH response from the router is abnormal and stuck during the high link utilization. The problem is identified as SSH traffic does not match in the ACL. Which action resolves the issue?
300-410 Exam Question 72
An engineer configured VRF-Lite on a router for VRF blue and VRF red. OSPF must be enabled on each VRF to peer to a directly connected router in each VRF. Which configuration forms OSPF neighbors over the network 10.10.10.0/28 for VRF blue and 192.168.0.0/30 for VRF red?


300-410 Exam Question 73
What is a characteristic of Layer 3 MPLS VPNs?
300-410 Exam Question 74
Refer to the exhibit.

Refer to the exhibit The enterprise users fail to authenticate with the TACACS server when a direct fiber link fails between RB and RD The NOC team observes Users connected on AS65201 fail to authenticate with TACACS server 192 168 1 1 Users connected on AS65101 successfully authenticate with TACACS server 192 168 1 1 All AS65101 and AS65201 users are configured to authenticate with the TACACS server Which configuration resolves the issue?

Refer to the exhibit The enterprise users fail to authenticate with the TACACS server when a direct fiber link fails between RB and RD The NOC team observes Users connected on AS65201 fail to authenticate with TACACS server 192 168 1 1 Users connected on AS65101 successfully authenticate with TACACS server 192 168 1 1 All AS65101 and AS65201 users are configured to authenticate with the TACACS server Which configuration resolves the issue?
300-410 Exam Question 75
Refer to the exhibit.

Refer to the exhibit A network engineer notices that R1 and R2 cannot establish an eBGP peering. The following messages appear in the log:

Which configuration must the engineer apply to R1 to restore the eBGP peering?

Refer to the exhibit A network engineer notices that R1 and R2 cannot establish an eBGP peering. The following messages appear in the log:

Which configuration must the engineer apply to R1 to restore the eBGP peering?
