Online Access Free Cisco.300-410.v2024-01-03.q227 Practice Test (Page 32)

300-410 Exam Question 151

Refer to the exhibit.

Refer to the exhibit. The administrator is troubleshooting a BGP peering between PE1 and PE3 that is unable to establish Which action resolves the issue?

A.Disable sending ICMP unreachables on P2 to allow PE1 to establish a session with PE3

B.Ensure that the PE3 loopback address is used as a source for BGP peering to PE1

C.Remove the traffic filtering rules on P2 blocking the BGP communication between PE1 and PE3

D.P2 must have a route to PE3 to establish a BGP session to PE1

300-410 Exam Question 152

Refer to Exhibit:

AS 111 wanted to use AS 200 as the preferred path for 172.20.5.0/24 and AS 100 as the backup. After the configuration, AS 100 is not used for any other routes. Which configuration resolves the issue?

A.route-mmap SETLP permit 10
match ip address prefix-list PLIST1
set local-preference 99
route-map SETLP permit 20

B.route-map SETLP permit 10
match ip address prefix-list PLIST1
set local-preference 110
route-map SETLP permit 20

C.router bgp 111
no neighbor 192.168.10.1 route-map SETLP in
neighbor 192.168.10.1 route-map SETLP out

D.router bap 111
no neighbor 192.168.10.1 route-map SETLP in
neighbor 192.168.20.2 route-map SE TLP in

300-410 Exam Question 153

Refer to the exhibit.

Refer to the exhibit. AS 111 mut not be used as a transit AS, but ISP-1 is getting ISP-2 routes from AS 111. Which configuration stops Customer AS from being used as a transit path on ISP-1?

A.ip as-path access-list 1 permit."

B.ip as-path access-list 1 permit ^$

C.ip as-path access-list 1 permit_111_

D.ip as-path access-list 1 permit ^111$

300-410 Exam Question 154

Refer to the exhibit.

Refer to me exhibit. The hub and spoke are connected via two DMVPN tunnel interfaces The NHRP is configured and the tunnels are detected on the hub and the spoke Which configuration command adds an IPsec profile on both tunnel interfaces to encrypt traffic?

A.tunnel protection ipsec profile DMVPN unique

B.tunnel protection ipsec profile DMVPN multipoint

C.tunnel protection ipsec profile DMVPN tunnel1

D.tunnel protection ipsec profile DMVPN shared

300-410 Exam Question 155

A network engineer must configure a DMVPN network so that a spoke establishes a direct path to another spoke if the two must send traffic to each other. A spoke must send traffic directly to the hub if required Which configuration meets this requirement?