Online Access Free 300-620 Exam Questions

Which Cisco ACI setting corresponds to the VMware MAC pinning?

• A.route based on physical NIC load
• B.route based on originating virtual port
• C.route based on IP hash
• D.route based on MAC hash

A Cisco ACI fabric is experiencing packet loss that originates from a bare metal server. The engineer must configure the syslog service to meet these requirements:
- The ACI syslog information must be collected with logging information from other network devices.
- The monitoring must only be performed on leaf 103 and leaf 104.
Which set of actions accomplishes these goals?

• A.Configure the Syslog Monitoring Destination Group to Local File logging.
  Create a Fabric Monitoring policy for ingress and egress bytes.
  Apply the Monitoring policy to the appropriate Switch Profile group.
• B.Configure the Syslog Monitoring Destination Group to Console logging.
  Create an Access Monitoring policy for egress packet drops.
  Apply the Monitoring policy to the appropriate Switch Profile group.
• C.Configure the Syslog Monitoring Destination Group to Console logging.
  Create a Fabric-Wide Monitoring policy for ingress packet drops.
  Apply the Monitoring policy to the appropriate Switch Profile group.
• D.Configure the Syslog Monitoring Destination Group to remote server logging.
  Create an Access Monitoring policy for ingress and egress packet drops.
  Apply the Monitoring policy to the appropriate Switch Profile group.

Which two protocols are used for fabric discovery in ACI? (Choose two.)

• A.LLDP
• B.OSPF
• C.ISIS
• D.DHCP
• E.CDP

An engineer must configure an L3Out to advertise a single summarized address for all Cisco ACI host routes. The summarized address must be advertised to the core switches that are physically attached to the ACI fabric. An external EPG is created with the required subnet. Which configuration set advertises the subnet to the remote peer?

• A.Set the external EPG subnet scope to Export Route Control Subnet.
  Associate a route control profile.
• B.Set the external EPG subnet scope to Export Route Control Subnet.
  Associate a route summarization policy.
• C.Set the external EPG subnet scope to Import Route Control Subnet.
  Associate a route control profile.
• D.Set the external EPG subnet scope to Import Route Control Subnet.
  Associate a route summarization policy.

An engineer configures an L3Out between BLeaf1 and Core1. A Cisco Nexus 9000 Series Switch runs in NX-OS mode, and the two devices must peer using OSPF. The devices in the network are configured as follows:
- BLeaf1 has been configured with the IP address 10.1.0.2/31 and the
router ID 0.0.0.2.
- Core1 has been configured with the IP address 10.1.0.3/31 and the
router ID 0.0.0.1.
- On Cisco ACI, the engineer has enabled OSPF using the default OSPF
settings.
- The engineer has configured OSPF on the NX-OS switch using the ip
router ospf ACI_peering area 1 command.
Which action brings up the OSPF adjacency?

• A.Disable Hello Timer on BLeaf1.
• B.Set and Auth Key on Core1.
• C.Configure Area 1 on BLeaf1.
• D.Change the MTU on Core1.