A.Increase interface MTU for all IPN routers to support VXLAN traffic

B.Connect all spines to the IPN

C.Configure the TEP pool of the new pod to be routable across the IPN

D.Configure anycast RP for the underlying multicast protocol

E.Configure MP-BGP on IPN routers that face the Cisco ACI spines

A.1

B.3

C.5

D.4

E.2

F.6

A.

B.

C.

D.

A.FTAG is used in Cisco ACI to add a label to the iVXLAN traffic in the fabric to apply the correct policy.

B.FTAG is used in Cisco ACI to add a label to the VXLAN traffic in the fabric to apply the correct policy.

C.FTAG trees in Cisco ACI are used to load balance unicast traffic.

D.FTAG trees in Cisco ACI are used to load balance mutli-destination traffic.

A.Leaf 101 forwards the ARP request to one of the proxy VTEP spines.

B.Leaf 101 switch consumers the ARP reply of VM2 to update the local endpoint table.

C.POD1 spine responds to the ARP request after the POD1 COOP is updated with the VM2 location.

D.Leaf 101 encapsulates the ARP request into a multicast packet that is destined to 225.0.37.192.