Online Access Free Cisco.300-630.v2024-06-11.q86 Practice Test (Page 4)

300-630 Exam Question 11

An organization migrates its virtualized servers from a legacy environment to Cisco ACI. VM1 is incorrectly attached to PortGroup IT|3TierApp|Web. Which action limits IP address learning in BD1?

A.Disable Remote EP Learn

B.Enable Enforce Subnet Check

C.Enable Rouge Endpoint Control

D.Enable GARP-based EP Move Detection Mode

300-630 Exam Question 12

An engineer must implement a full mesh Cisco ACI Multi-Site architecture. Which action must be taken on each spine to accomplish this goal?

A.Configure BGP-EVPN Router-ID

B.Configure Multi-Pod Data-Plane TEP

C.Configure Overlay Unicast TEP

D.Configure Overlay Multicast TEP

300-630 Exam Question 13

Refer to the exhibit. Between Cisco UCS Fls and Cisco ACI leaf switches, CDP is disabled, the LLDP is enabled, and LACP is in Active mode. Which two discovery protocols and load-balancing mechanism combinations can be implemented for the DVS? (Choose two.)

A.CDP enabled, LLDP disabled, and LACP Active

B.CDP disabled, LLDP enabled, and MAC Pinning

C.CDP enabled, LLDP enabled, and LACP Active

D.CDP disabled, LLDP enabled, and LACP Passive

E.CDP enabled, LLDP disabled, and LACP Passive

F.CDP enabled, LLDP disabled, and MAC Pinning

300-630 Exam Question 14

Refer to the exhibit.

Between Cisco UCS Fls and Cisco ACI leaf switches, CDP is disabled, the LLDP is enabled, and LACP is in Active mode. Which two discovery protocols and load-balancing mechanism combinations can be implemented for the DVS? (Choose two.)

A.CDP enabled, LLDP disabled, and MAC Pinning

B.CDP enabled, LLDP disabled, and LACP Passive

C.CDP disabled, LLDP enabled, and LACP Passive

D.CDP enabled, LLDP disabled, and LACP Active

E.CDP disabled, LLDP enabled, and MAC Pinning

F.CDP enabled, LLDP enabled, and LACP Active

300-630 Exam Question 15

What is the purpose of the Forwarding Tag (FTAG) in Cisco ACI?

A.FTAG is used in Cisco ACI to add a label to the iVXLAN traffic in the fabric to apply the correct policy.

B.FTAG is used in Cisco ACI to add a label to the VXLAN traffic in the fabric to apply the correct policy.

C.FTAG trees in Cisco ACI are used to load balance unicast traffic.

D.FTAG trees in Cisco ACI are used to load balance mutli-destination traffic.

Other Version: 101Cisco.Practicetorrent.300-630.v2022-04-12.by.beacher.40q.pdf; 1244Cisco.300-630.v2022-01-22.q40; 1225Cisco.300-630.v2021-09-22.q41; 64Cisco.Passtestking.300-630.v2021-08-02.by.veromca.45q.pdf

Latest Upload: 111ISTQB.CT-AI.v2026-06-18.q68; 226IIA.IIA-CIA-Part3.v2026-06-17.q220; 147WGU.Introduction-to-IT.v2026-06-17.q67; 194CompTIA.220-1202.v2026-06-16.q110; 128TheInstitutes.CPCU-500.v2026-06-16.q25; 206ACAMS.CAMS7-CN.v2026-06-16.q170; 223CBIC.CIC.v2026-06-15.q123; 142Peoplecert.ITIL-4-Specialist-High-velocity-IT.v2026-06-15.q16; 244HashiCorp.Terraform-Associate-004.v2026-06-15.q126; 152Peoplecert.ITILFNDv5.v2026-06-15.q26

300-630 Exam Question 11

300-630 Exam Question 12

300-630 Exam Question 13

300-630 Exam Question 14

300-630 Exam Question 15

Download PDF File