Online Access Free 350-050 Exam Questions

AP A is in AP group ONE and AP B in is AP group TWO. AP group ONE assigns the interface Marketing to the corporate WLAN, whereas AP group TWO assigns the interface Sales to the same WLAN. What happens if a client roams from AP A to AP B while connected to the corporate SSID?

• A.The client will reconnect with a new IP address from the Sales subnet.
• B.The client will keep its Marketing subnet IP address, and roaming will be seamless if the appropriate key management is used.
• C.The client will keep its Marketing subnet IP address, but roaming will not be seamless.
• D.No roaming is possible.
• E.A mobility tunnel will be established between the two APs, and the client will be allowed to keep its IP address.

Which three of these options are variables used within the TPC algorithm to determine the transmit power? (Choose three.)

• A.antenna gain (dBi)
• B.Tx power control threshold
• C.client SNR cutoff value
• D.RSSI of third highest neighbor above the threshold
• E.SNR of third highest neighbor above the threshold
• F.number of neighbors
• G.Tx Max
• H.antenna gain (dBm)

Refer to the exhibit.

Which EAP type does the diagram illustrate?

• A.PEAP
• B.EAP-GTC
• C.EAP-TLS
• D.LEAP
• E.EAP-MD5
• F.EAP-FAST

You are on the U.S. East Coast (EST time zone, UTC-5) and configure NTP on your Cisco WLC. The Cisco WLC web GUI shows the correct time and date, but your APs are off by 5 hours. Which statement is true?

• A.This behavior is normal because the APs show UTC time.
• B.You need to configure the time zone on the APs.
• C.You need to enable time-zone synchronization between the APs and Cisco WLC.
• D.You need to configure the NTP server on the APs.
• E.APs support only an SNTP server, not an NTP server.

When designing a WLAN network using Cisco 1142 APs to support both voice services (Cisco 7921 IP Phones) and data services, what design principles are true? (Choose 2)

• A.RRM should not be used as it is not designed for wireless voice services and will adjust the channel and Tx power settings to non optimized values for voice services.
• B.RRM should be used because it is the only way to ensure that channel and Tx power are configured to support voice services.
• C.802.11n data rates should be enabled to improve overall performance even if the Cisco 7921 IP Phones do not support 802.11n data rates.
• D.Ensure proper floor coverage to ensure good voice quality (-67 dBm, 20% cell overlap, and 19 dB channel separation).
• E.802.11n data rates should not be enabled as the Cisco 7921 IP Phones are not 802.11n capable. As such, no performance improvement is expected for the voice clients upon enabling 802.11n data rates.
• F.-67 dBm, 20% cell overlap, and 19 dB channel separation is impossible to achieve. Therefore, a site survey to ensure required RSSI coverage is top priority to ensure good voice quality.