Explanation
There is nothing special with the configuration of Gi0/0 on R1. Only Gi0/0 interface on R2 is assigned to VRF VPN_A. The default VRF here is similar to the global routing table concept in Cisco IOS

Explanation
R3 advertises BGP updates to R1 with multiple AS 100 so R3 believes the path to reach AS 200 via R3 is farther than R2 so R3 will choose R2 to forward traffic to AS 200.

In the 5GHz spectrum some of the channels used by 802.11 are subject to Dynamic Frequency Selection (DFS) requirements. This is due to our clients coexistence with other RF technologies such as Maritime, Aviation and Weather RADAR.
Dynamic Frequency Selection (DFS) is the process of detecting radar signals that must be protected against interference from 5.0 GHz (802.11a/h) radios, and upon detection switching the operating frequency of the 5.0 GHz (802.11a/h) radio to one that is not interfering with the radar systems.
Reference:
Although DFS helps reduce interference with radar systems but "DFS channels" refer to the 5GHz channels that require DFS check. In other words, DFS channels are channels that may interfere with radar signal. Therefore we should disable these DFS channels -> Answer C is correct.
UNII-2 (5.250-5.350 GHz and 5.470-5.725 GHz) which contains channels 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, and 140 are permitted in the United States, but shared with radar systems. Therefore, APs operating on UNII-2 channels are required to use Dynamic Frequency Selection (DFS) to avoid interfering with radar signals. If an AP detects a radar signal, it must immediately stop using that channel and randomly pick a new channel.