Online Access Free 350-501 Exam Questions

Refer to the exhibit. A network engineer is implementing multicast Source-A to send a multicast stream for Receiver-A, and multicast Source-B to send a multicast stream for Receiver-B. Router RC forwards the IGMP host a report and leaves messages to IP address 192.168.10.1. How must the multicast features be implemented to prevent RB from receiving multicast flooding from Source-A?

• A.Configure PIM-SSM on RB and RC interface Ge 0/0.
• B.Enable ip pim passive on RB interface Ge0/0.
• C.Enable ip pim neighbor-filter on RC interface Ge0/0.
• D.Change the helper-address value to 192.168.10.2 on RC.

Refer to the exhibit. An engineering team must update the network configuration so that data traffic from router A to router D continues in case of a network outage between routers B and C.
During a recent outage on the B-C link, the IGP traffic path was switched to the alternate path via routers E and F, but label forwarding did not occur on the new path. Which action ensures that traffic on the end-to-end path continues?

• A.Bind the BFD protocol with IGP on all routers
• B.Enable MPLS LDP IGP Synchronization on all routers
• C.Enable LDP Session Protection on routers A and D
• D.Configure the same hello timer values for IGP and LDP

Refer to the exhibit. The operations team is implementing a route-map policy. Traffic from source
192.168.30.1 must reach the customer network 192.168.1.1 via the secondary link R4-R6-R5. All other traffic from the data center to the customer network must prefer the primary link R4-R3-R2.
Which action must be taken to meet the requirement for prefix 192.168.1.1/32?

• A.Apply route-map PrefixBlock out on R3 with R4 BGP peering.
• B.Apply route-map PrefixBlock in on R6 with R5 BGP peering.
• C.Apply route-map High-LP on R6 with R4 BGP peering.
• D.Apply route-map Low-LP in on R4 with R3 BGP peering

Refer to the exhibit. Assume all other configurations are correct and the network is otherwise operating normally.
Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

• A.The neighbor relationship is up
• B.The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement
• C.The neighbor relationship is down because R1 believes R2 is in AS 65012.
• D.The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family

What is the role of NFVI?

• A.intrusion detection
• B.network address translation
• C.domain name service
• D.monitor