350-601 Exam Question 91
An engineer has a primary fabric that is named UCS-A and a secondary fabric that is named UCS-B. A certificate request that has a subject name of sjc2016 for a keyring that is named kr2016 needs to be created.
The cluster IP address is 10.68.68.68.
Which command set creates this certificate request?
The cluster IP address is 10.68.68.68.
Which command set creates this certificate request?
350-601 Exam Question 92
An engineer is implementing NetFlow on a Cisco Nexus 7000 Series Switch. Drag and drop the NetFlow commands from the left into the correct order they must be entered on the right.


350-601 Exam Question 93
An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSPF.
However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected.
Which configuration must be applied to both Nexus switches to meet these requirements?
However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected.
Which configuration must be applied to both Nexus switches to meet these requirements?
350-601 Exam Question 94
Refer to the exhibit.
An engineer must configure a Fibre Channel device alias named TEST for a device attached to port fc1/9 of a Cisco Nexus Series Switch. Which command set completes the configuration?
An engineer must configure a Fibre Channel device alias named TEST for a device attached to port fc1/9 of a Cisco Nexus Series Switch. Which command set completes the configuration?
350-601 Exam Question 95
Drag and drop the characteristics from the left onto the NAS protocols on the right. Some characteristics are used more than once

