350-601 Exam Question 341
Refer to the exhibit.
What is the result of implementing this configuration?
What is the result of implementing this configuration?
350-601 Exam Question 342
A network architect considers a Cisco HyperFlex design solution for a company. The proposed solution is for a virtual environment that is not performance-sensitive, but the solution must have high storage capacity and a low cost. Which Cisco HyperFlex storage configuration should be used?
350-601 Exam Question 343
An engineer is implementing NetFlow on a Cisco Nexus 7000 Series Switch. Drag and drop the NetFlow commands from the left into the correct order they must be entered on the right.
350-601 Exam Question 344
An engineer must configure monitoring on a Cisco MDS 9000 Series Switch for a critical interface prone to sporadic data traffic surges. A Remote Network Monitoring alarm must be configured to sample the number of incoming octets on the critical interface every 300 seconds and must be triggered if the traffic exceeds a certain threshold. Which command must be run?
350-601 Exam Question 345
An engineer mus! configure HSRP protocol on two Cisco Nexus 9000 Series Switches running a virtual port channel. In addition, the HSRP implementation must meet these requirements:
* It must allow more than 500 groups.
* switch 1 must act as the primary switch.
* Both switches must use a user-defined hardware address.
Drag and drop the commands from the right to complete a configuration of the HSRP on the left. The commands are used more than once. Not all commands are used.
* It must allow more than 500 groups.
* switch 1 must act as the primary switch.
* Both switches must use a user-defined hardware address.
Drag and drop the commands from the right to complete a configuration of the HSRP on the left. The commands are used more than once. Not all commands are used.
