Online Access Free 352-001 Exam Questions

As part of the security protocol for your network design, you have designated that operator 82 is enabled for DHCP snooping. When option 82 is enabled, which information will be added to the DHCP request?

• A.switch MAC address and switch IP address
• B.switch IP address and VLAN, module and poet
• C.remote ID and circuit ID
• D.switch MAC address and VLAN module and port

When designing fast convergence on a network using loop-free alternate, on which two basis can the next-hop routes be precomputed? (Choose two)

• A.Per failure type
• B.Per prefix
• C.Per neighbor
• D.Per network type
• E.Per link

An existing wireless network was designed to support data traffic only. You must now install context Aware services for location tracking changes must be applied to the existing wireless network to increase the location accuracy? (Chose two)

• A.Install additional access points in monitor mode where the co-channel interference would otherwise be affected
• B.Add access points along the perimeter of the coverage area.
• C.Fine tune the radio configuration of the access point to have a higher average transmission power to achieve better coverage
• D.Use directional antennas to provide more cell overlapping
• E.Increase the access point density to create an average inter-access point distance of less than 40 feet or 12.2 meters

A engineer has been tasked to design an IPv6 wireless sensor network using IEEE 802.15.4 to support an IoT project. Which two protocols does the engineer need to utilize for this design? (Choose two)
802.11

• A.802.11ac
• B.6LoWPAN
• C.802.11ax
• D.VPN

A network design decides to connect two labs together to test multicast features interoperability. Before the networks are connected together the network administrator mentions that overlapping multicast IP addresses between the two labs will cause issues because all the routers on the network are provisioned for Source-Specific Multicast using IGMPv3. Which statement about the connectivity of both multicast domains is true?

• A.IGMPv3 requires a unique RP when connecting both labs together
• B.IGMFV3 can support overlapping multicast IP addresses between the labs
• C.IGMPv3 requires NAT to support the overlapping multicast IP addresses between the labs.
• D.IGMPV3 cannot support overlapping multicast IP addresses between the labs