Online Access Free 600-601 Exam Questions

Exhibit: Refer to the exhibit. Which port should a PLC with IP address 192.168.3.65 be plugged into in order to communicate to the rest of the network?

• A.FastEthernet1/5
• B.FastEthernet1/2
• C.FastEthernet1/1
• D.FastEthernet1/4
• E.FastEthernet1/3

Which protocol is a secure alternative to Telnet?

• A.SMTP
• B.SNMP
• C.HTTP
• D.SSH
• E.FTP

What is the leading cause of fiber-optic link failure?

• A.crushed fiber
• B.poor testing practices
• C.bad connectors
• D.contaminants

Exhibit: Which two statements are correct for a safe wiring installation to the terminal block of the switch or endpoint? (Choose two.)

• A.Verify that the DC power circuit includes an overcurrent protective device that limits the DC current to 5 A.
• B.Because this is a low-voltage DC circuit, anyone can install this wiring without electrical training or qualifications.
• C.Verify that DC power is live and within 24 VDC voltage range before starting wiring.
• D.Insert a green ground wire into the terminal block that is marked RT for return.
• E.A ground wire can optionally be connected to the screw terminal on the front of the switch.
• F.Connect the positive 24 VDC conductor to the V terminal and connect the negative 24 VDC return wire to the RT terminal.

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

• A.IEEE1588 and PTP are important for ensuring real-time synchronization.
• B.CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
• C.EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
• D.EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.
• E.Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
• F.The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.