Online Access Free 642-035 Exam Questions

Refer to Exhibit 2.




Which of the following options is true about why this C-Series vHBA will not allow SAN boot?

• A.The Class of Service must be set to '1' to negotiate Priority Flow Control for FCoE traffic
• B.Persistent Binding is required by all operating systems
• C.The default VLAN must match the FCoE VLAN
• D.The WWPN and WWNN must match

As a Cisco UCS administrator, you have a large deployment of C-Series servers. You decide to integrate these into a Cisco UCS Manager environment to simplify management.
Which two of these will you need to purchase? (Choose two.)

• A.two I/O modules
• B.two fabric extenders
• C.two fabric interconnects
• D.a dedicated Cisco IMC

Using CLI/GUI to troubleshoot packet flow from server to the fabric, you discover that the blade server 1/7 in a Cisco UCS B-Series Blade Server is running slower than expected. You must troubleshoot the problem by using packet tracing. Which three commands can you use to identify the uplink from the Cisco UCS Fabric Interconnect to the external network of the server? (Choose three.)

• A.show service-profile circuit server 1/7
• B.show pinning border-interface
• C.show fex detail
• D.show interface-fex fabric
• E.show pinning border-interface active
• F.show pinning server-interfaces

A Cisco UCS chassis has two ports on I/O Module 1 connected to Fabric Interconnect A, and two ports on I/O Module 2 connected to Fabric Interconnect B.
The I/O modules are connected to ports 1 and 2 on their respective fabric interconnects, and end host mode is configured. After a link failure occurs on port 1 of I/O Module 1, what happens to the traffic that was pinned to that link?

What should you do when you see faults during the initial setup and discovery process?

• A.Log them and try to address the first one.
• B.You can safely ignore these faults.
• C.Take note and address the faults.
• D.Reboot until the error messages go away.