Online Access Free 642-732 Exam Questions

Refer to the exhibit. A company requires a multi-point bridge solution with Cisco 1400 series bridges. The central bridge (B1) is set to 10 dBm, the manufacturing remote bridge (B2) is set to 20 dBm, the inventory remote bridge (B3) is set to 20 dBm, and the shop remote bridge (B4) is set to 10 dBm. What is the maximum allowed power setting for all four bridges?

• A.B1=24dBmB2=12dBmB3=12dBmB4=12dBm
• B.B1=10dBmB2=24dBmB3=24dBmB4=24dBm
• C.B1=20dBmB2=20dBmB3=20dBmB4=20dBm
• D.B1=24dBmB2=24dBmB3=24dBmB4=24dBm
• E.B1=12dBmB2=12dBmB3=12dBmB4=12dBm
• F.B1=12dBmB2=24dBmB3=24dBmB4=24dBm

If you are calibrating for 2.4 GHz and the site will not be using 802.11 and 802.11b data rates, what should be done to ensure an accurate calibration?

• A.Make sure that you are using an 802.11b client when calibrating.
• B.Make certain that there are no legacy clients when performing the calibration because they will disrupt the process.
• C.Make sure to use a client that supports both 802.11b/g and 802.11a.
• D.Make sure that the access points have the unused rates disabled.

When designing for location services, how many APs should be heard by each location-ready AP and at what dBm signal level? (Choose two.)

• A.As many APs as possible at a signal level of -72 dBm or better
• B.At least 5 to 6 APs at a signal level of -75 dBm or better
• C.At least 1 to 2 APs at a signal level of -67 dBm or better
• D.At least three and preferably four at a signal level of -75 dBm or better
• E.No more than 3 APs at a signal level of -72 dBm or better

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?

• A.25 percent
• B.10 percent
• C.15 percent
• D.Application dependent
• E.20 percent

When performing a post-installation audit with an auditing tool such as Ekahau, which three steps are associated with the passive portion of the audit? (Choose three.)

• A.Check for co-channel interference.
• B.Survey by SSID to ensure roaming is taking place.
• C.Verify that the network traffic of physical data rate and packet loss meets user requirements.
• D.Check that you have adequate signal levels as surveyed.
• E.Verify AP announced data rate coverage.
• F.Make sure you emulate your customer client.