Online Access Free 1Y0-240 Exam Questions

Scenario: A network engineer plans to configure an Active Directory Server as the default authentication for a Citrix ADC deployment and provide users with the option to change their password if it is expired. Which two actions should the engineer take to configure this authentication requirement on the Citrix ADC system? (Choose two.)

• A.Configure Authentication server with SSO name attribute.
• B.Select security type as SSL on Authentication policy.
• C.Configure a pre-authentication policy.
• D.Configure Authentication server with allow Password change option.

A Citrix Administrator needs to utilize the client IP address as the source IP address for the Citrix ADC to server connections.
Which mode on the Citrix ADC will the administrator utilize to meet this requirement?

• A.USNIP
• B.Layer 3 Mode
• C.USIP
• D.Layer 2 Mode

Scenario: A network engineer has configured GSLB for a multisite environment. All GSLB services show as UP with an UP MEP status. The engineer has observed that DNS queries are directed to the SNIP of the Citrix ADC; however, no DNS response is being received. How can the engineer resolve this issue?

• A.Create a load balancing virtual server for DNS.
• B.Select the "Send all "active" service IPs' in response (MIR)" option.
• C.Change the DNS delegation to the NSIP.
• D.Add an ADNS service on the SNIP.

An engineer has bound three monitors to a service group and configured each of the monitors with a weight of 10. How should the engineer ensure that the members of the service group are marked as DOWN when at least two monitors fail?

• A.Configure the service group with a threshold of 21.
• B.Configure the service group with a threshold of 20.
• C.Re-configure the weight of each monitor to 0.
• D.Re-configure the weight of each monitor to 5, and configure the service group threshold to 15.

Scenario: The Citrix ADC has been connected to two external networks provided by different Internet service providers(ISPs). Dynamic routing is not enabled. Traffic is expected to use the first ISP (through the 10.50.1.1 router) if possible and the second, slower ISP (through the
10.51.1.1 router) only if the Primary ISP fails. Which two commands could the network engineer execute to configure the routes? (Choose two.)

• A.add route 0.0.0.0 0.0.0.0 10.51.1.1 -cost 3 -monitor PING-DEFAULT
• B.add route 0.0.0.0 0.0.0.0 10.50.1.1 -cost 15 -msr ENABLED
• C.add route 0.0.0.0 0.0.0.0 10.51.1.1 -cost 10 -monitor arp
• D.add route 0.0.0.0 0.0.0.0 10.50.1.1 -cost 5 -monitor PING