Online Access Free 1Y0-350 Exam Questions

Scenario: A NetScaler environment uses two-factor authentication and the second authentication method is AD. A user logs in to the environment but does NOT receive access to the resources that the user should have access to.
How can an engineer determine the AD authentication issue on the NetScaler?

• A.Check NSlogs.
• B.Check the authorization configuration.
• C.Use the cat aaad.debug command.
• D.Use nsconmsg.

What should a network engineer configure to set high availability for a load balanced virtual server?

• A.Load balancing services
• B.A backup virtual server
• C.Load balancing policies
• D.Session persistence

NSROOT is the only account configured with super user rights.
In order to initiate the password recovery procedure, the engineer must __________. (Choose the correct option to complete the sentence.)

• A.logon using nsrecover/nsroot and reallocate licenses
• B.connect using SSH to the NetScaler device
• C.connect to the physical NetScaler device
• D.logon using SCP and modify ns.conf

Scenario: A virtual server named New_Server has been disabled to perform an emergency upgrade; however requests from clients are NOT being redirected to the maintenance page.
The redirected URL configuration is:
>set cs vserver Website_main -lbvserver New_Server -backupVserver Backup_Server redirectURL http://www.mydomain.com/maintenance -soMethod Connection -soThreshold 1000 soPersistence enabled
Why are requests from clients NOT being redirected to the maintenance page?

• A.The backup virtual server is unavailable.
• B.The backup virtual server takes precedence over the redirect URL.
• C.The spillover persistence has been activated.
• D.It has not been linked to content switching policies.

Scenario: The network engineer has created a monitor and bound it to a service group containing four web servers to verify that the web application responds. During routine maintenance one of the web servers is shut down; however, the server state remains UP and user requests are still attempting to communicate with the server.
What could be causing this problem?

• A.The monitor is not bound at the correct bind point.
• B.The server has been disabled.
• C.The NetScaler configuration has not been saved since before the monitor was bound.
• D.Health monitoring is disabled for the service group.